E60TLESM
Engine is spitting back fuel when engine is running and is bogging out when trying to accelerate.
Carbs have been cleaned and new inlet needles and seats have been installed. Floats...
Type: Posts; User: vmax535
E60TLESM
Engine is spitting back fuel when engine is running and is bogging out when trying to accelerate.
Carbs have been cleaned and new inlet needles and seats have been installed. Floats...
413293
413292
VST pressure dropped first.found blockage in fuel line. Inner liner was pushed in when putting winterizing solution tank on over 9 years. Replaced line all good thanks.
But to answer my own...
Thanks for your input.
Will advise
By falling on its face ...it's loosing power, like it's running out of fuel.
Tach is analog.
Serial number
1B847110
My mistake
Thank you
Engine is falling on its face at 5200rpm.
Gauges read 91 air / 106 fuel.
Checked VST fuel pressure 25 psi.
Checking and replacing primer bulb. Feels soft.
Spec says 94 / 108. Will this difference...
Poppet valve, stuck shut, plugged or something.
Looking for "Tricks of the Trade" in removing a 1996 S225TXRU power head that I have snapped two of the long bolts securing the PH to the midsection, one on each side. I am able to get the forward...
Guy's I feel like an idiot asking this but if some one has a V6 Merc EFI please tell me the throttle shaft rotation from the starboard side view.
Regards,
Dan
Just wondering, after how many hrs did this happen
I would agree with that comment if there were bullet connectors that could be mixed up. This harness has a 3 wire clip connector. It only joins one way.
Please confirm throttle shaft rotation...
By the way it is reacting you would think that may be the case.
If I look from the starboard side of the engine the butterfly throttle shaft that rotates the TPS turns clockwise when the throttle...
Hi I'm new to BBC, maybe my 1st post needs approval or I messed up. My question is that when I measure voltage on the TPS I get 3.80vdc at idle and 1.69vdc at WOT The manual stats .95vdc @ idle an...
Hello everyone I am new to BBC and am enjoying all the info.
I have just rebuilt a 1996 250XLEFI, OG424429, I'm having issue setting the TPS. Manual states 0.95vdc @ idle and 3.80vdc @ WOT.
...