Search:

not a brown recluse.

+1 for Boat Buckle. They were the first thing I put on my Z7 trailer when I got it home from the dealer.

I'm one of those "other guys" who decided not to take the long term low note and instead went and got 3% on 5 years from my CU. Disadvantage is my note is higher on my 2014 z7 with the short term. ...

I did it when they had the WSOF on Cross Lake here in Shreveport and it was a good learning experience. Basically just shadowed a couple of them from a safe distance and dropped my talons and had a...

I had a relative (who shall remain nameless) who bought a boat with a bad motor from another relative (who shall remain nameless). Relative 2 knew it was bad and pawned it off on relative 1 anyway...

1991 16'8 Cajun. that thing was a tank.

They do. Even when not in use the Talon circuitry on the new Gen has a small drain on the battery. I just bought a master cutoff a few days ago and installed it between the battery and the talons...

Thank you very much. 2 inch drop was what I needed and that did put me at about 20 top of ball.

Anyone know what the level tongue height on a 2014 z7 single axle trailer is? I'm on the other side of town from my boat and cannot remember it for the life of me. Something says 17 inches but I...

Could be a short you don't see till something gets wet.

If you are worried about accidental deployment or battery drain until you get cutoff switches installed you can remove the fuse in the hot lead for the talon. It's a simple way to be safe until you...

You don't need more than 6 on a z7.

Yep way to low. I did these myself.

How much boat are you planning on? A jeep would probably be ok for a single axle trailer up to maybe 17 feet or so, but I have a feeling anything over 17 or double axle is going to yank that jeep...

That's excellent thanks! I just booked for the first week of August.

Here's the link to their website:

Toledo Bend Lake - Bridge Bay Resort


EDIT: Ah, I think I see why, it's not actually in Many, it's about 5 miles West of Negreet. Has a Many address on the...

I normally fish Caddo lake in north west Louisiana but in August I plan to take my son down to Toledo bend for a week. I haven't fished the bend in probably 10 years and usually just southern Texas...

Took me 2x2 hour sessions to get mine all done, including the tilt brackets and wiring as well. I did have BPS do the jackplate, just to make sure I didn't do anything to void my motor warranty, but...

It's not necessarily the best out there, but for a Z6 it will work great and be all you ever need.

Socket set, screwdrivers and a portable jump starter.

Right that's what I've seen. No to the sandwich brackets, ok to the jackplate brackets.

Get a 6 inch Manual Zlock jackplate, set it to prop shaft 3.5 below pad, lock it down and add your talons. You won't regret it. Boat will handle better, holeshot better, and less porpoise action. ...

Happens all the time. Very common with house buyers too and a lot more painful when they cause a home to go off the market for weeks and then they can't get financing. Be glad it was just a boat..

+1. Helluva rig for the money and you don't have to get work done at BPS. But if you are not wanting nitro you might consider a used Ranger. 30k would put you in the 5-10 year old used range on...

Same here, that's just like I did mine.