most chargers are the Dual pro and will NOT charge lithiums...
Type: Posts; User: Buckdaddy
most chargers are the Dual pro and will NOT charge lithiums...
ok Wayne it is the built in Mega transducer. the boat is suppose to be here in a few weeks. just trying to get everything I need to install it. so it looks like the two methods do the same if reading...
Here is what I have on the bow. 12 MDI G4, 10 MDI G4 and M360 also ultrex with built in Mega transducer. what would be the best setup and additional cables for this combination? I've been reading...
following
following
did you run separate power up front for all those units?. if so how was your setup?
I had a similar issue with mine blowing the SAME tire. so I found out the fender was welded wrong. if I hit a bump it would bounce and the fender would hit the tire. they took it back and corrected...
price on 12" sent to 37036
Hey Ken what are your terms? is it 100% financing or is it 10% down? thanks
that's the setup I have it......
Hey Wayne I have a question on the two antennas. if I mark a waypoint at the console and stop to fish it my front graph is off quit a bit. do I need to change something?
I thought I’ve tried turning them off both ways. But I will double check again. Thanks Wayne. So Wayne do I need to add the other transducer? Or just share the one?
Ok guys I have a few questions. First I have a helix 10si and a 9si at the console on the same transducer. I also have a hs as gps antenna all going through a switch. Every time I power them up I get...
I have been looking into this also. Since I am new to hummingbirds. I have helix's, what all do I need to make this work? and what all data does it give you ? do I need anything special for the merc...
Thanks guys. Big relief.
Ok so here is what I have existing. I have a mega 10si G2N at the console with the transom SI transducer and a mega 9 DI G2N with a as hs gps antenna at the bow with a trolling motor transducer....
can you mount one next to a point one antenna? or will they interfere with each other?
Price On 10" Please with Gauge......
Thanks PHNX ed I'm still adjusting the motor height. I'm getting about 70 now but my RPM Are only 5600 so thinking of swapping to the fury 25p 3 blade and see if that helps. It thanks for the input....
Yes that is the biggest difference that I have noticed coming from the ranger.
Just liked the layout and ride of the Phoenix. Don't get me wrong ranger rides good. But the Phoenix takes these big waves on ky lake a whole lot better. It's just a boat you have to drive. But I'm...
Yes that would be greatly appreciated.....thanks guys
I have the same setup with the ultrex but when i measure from the bounce buster to the floor it's 9" the specs says 5-8" just wondering what yours was.? Thanks
Oh thanks bye the way. Lol
Really I will give that a try tonight then. Hopefully it helps if not I have to take it to the dealer Friday I will get them to take it out and see how they do.