Thanks! I was gonna check the gauge first anyways. Good to know I can check the sender from there.
Type: Posts; User: 01ChamP196
Thanks! I was gonna check the gauge first anyways. Good to know I can check the sender from there.
Hey y'all! The fuel gauge on my boat doesn't work. Hasn't worked since way before I bought it. I fear the issue is the sending unit in the gas tank. Can I get to that unit without removing the top...
Hello,
I have a Humminbird 998C on the bow. Transducer running down the trolling motor. The top 2-3 ft of the reading shows a blue bar. The area below that reads as it should. Anyone ever seen...
I'm the one who needs to go on a diet! :laugh:
I just fished my first tourney out of my 196 DCX. The hole shot is typically impressive, but with two guys and livewell full of water and fish, it was pretty sluggish. 200 hp Yamaha Vmax running a 25...
PM Sent
Thanks for all the feedback! I think I'm gonna go with sanding the holes and hoping to find a clip.
Hey guys! Few things. First, my pedestals fit in the holes but are a PITA to remove. Takes 2 grown men and a strap wrench. Anybody ran into this and got a fix for it? I believe they are 1.77 inch...
So I have a master switched wired up that kills the pro trim and bow trim. Leaving the motor and throttle trim. It was off when the trim stuck so that rules out those two. I got it to stick going up...
I can't replicate the issue today. Sunny day. What are the chances it dried itself out?
What's the fix then? Replace the faulty switch?
Hey all,
I have a 2001 196 DCX with a Yamaha VMax 200. Over the past week my battery has been dead with my motor trimmed all the way up everytime I check on my boat. Has anyone had experience with...
How difficult is it to remove the rod tube tubes?
Thanks for all the support! I can't wait to get some bass juice on the carpet.
Here you go:
https://i.postimg.cc/zXX4G9vS/20191026-150106.jpgimage hoster
Happy to be a part of the ChampioN family!
I was just planning on not using it, or using it for oil, stabil, etc.
That's the wiring harness I'd assume. Runs to the graphs and trolling motor.
I have a 2001 196 DCX Elite that is missing the plastic liner in one of the back driver side storage boxes. See images below:
Normal:
https://i.postimg.cc/9QmkZnx5/20191028-180318.jpg
...
Just got it home this weekend! Topped out around 64 at WOT. Plenty of speed for me
2001 Yamaha VMax 200 hp. 3.1 L. Running a 25P Tempest
Do you have a jackplate? If so, how high do you run your motor?
Hello everyone!
I'm new to the Champion forum as I'm looking at a 2001 196 DCX Elite. Going to test drive it Saturday, but before I go: Does anyone have one of these boats or know details about...