Thank you
Type: Posts; User: BIG ORANGE BASSIN
Thank you
Does the motor have to be running to get the four beep warning or will you get it with key in on position? Thanks
My engine oil tank sensor is a rod without a float that slides up and down as seen in photo when I removed sensor from reservoir and turn key on there are no beeps for low oil lever. Any suggestions...
Ok I see orange dot is there a chrome coating under the black Thanks
Which groove does t1 ring go in? Thanks
Is it ok to reuse rod bearing bolts on 2006 Optimax 150 1B319811 thanks
Will the rings shrink a little setting in 20 -30 degree weather that can affect gap? Thanks
What should ring end gap be?
How to tell if rings are still good?
I have a 2006 OPtimax 150 serial number 1B319811 with damage to cylinder wall does anyone know where can get a tool to remove sleeve? Can I replace it with the stock size that's in it? Thanks
Is there a difference between the top and bottom ring? Thanks
Trying to find rings for motor are both the piston rings the same if not can you give me part numbers for rings for one cylinder Thanks
I pulled the reed block and back side was covered with thick oil motor hadn't been started in months can the combustion chamber on the head be milled to remove damage? Thanks
My 2006 OPtimax has no compression on number 6 cylinder the piston edge is been destroyed there's aluminum on the wall of cylinder but don't see any deep scratches would like input on which way I...
Thanks for your help
Installing carpet on 99 210 Blazer should I paint the aluminum compartment lids or put glue on bare metal? Thanks
Does the extended transom do you still measure the motor height level with end Of the hull? Thanks
Did you mean centered between Reverse and Forward?
I have about about quarter inch play in shift cable is this normal both cables are new? Thanks
What is considered perfect neutral?
Yes I have a bushing I didn't realize it is removable thanks
I see the two holes the cable barrels fit one above the other they fit in the holes pretty snug but I don't see a bushing anywhere Thanks
Thanks for your help are you talking about the plastic piece that snaps closed to hold shift and throttle in place? I bought motor from someone who bought new one and he removed some part to use on...
I bought used LU put on and won't go in gear jus making grinding noise I put new shift cable on how manual said I can put in neutral and it will spin in both directions and while turning prop in...
Motor serial number 1B 319811!