Search:

PM sent

Depends on how heavy the line is. 6-8# is do a sweep with a little "Snap", 10-12# a little more "Pop", whereas with 12-15# I try to turn them "Inside Out" !!

The connections on the Blue Seas are Bat 1, Bat 2, and Output. So you'd connect the Pos to the Trolling Motor to the OUTPUT post.

What you want to consider most is, not the towing as much as the STOPPING power of the tow vehicle. Then also consider the lakes you fish most. How steep are the roads to get there and how steep is...

I'll take it. PM sent, send me your PayPal

Should be some part numbers on the one you have now. Google them. They are not used just for Ranger Boats.

Go to an Upholstery supply and get this. Spray both sides, let it get 'Sticky' then press it down.

PM sent

You charger has a set of leads that charges 36v and one that chargers 12v both off the same charger ??

I had/have one and was not impressed. It did ok thru sparse weeds and grass, but didn't work well in heavier weeds. I've heard some guys put 2 on and it works much better. i don't fish weeded...

New, gray, no red !!!

https://www.westernbass.com/forum/z520r-fold-down-pedestal-seats-t146657.html?sid=c50fb5e01d3060e22ed44cf7abc873b2

I went with the Fulton F-2 clamp on and used a mounting block with it. Best and easiest jack ever !!!

Be sure to use ALUMINUM Rivets too. If you ever have to replace one, they're easy to drill out.

This is the best stuff I've found. Been using it for years !! On Amazon !!

Remove the lid from the boat. Drill out the existing rivet heads and punch the remaining part into the lid. Drill the hinge and lid with a 1/4" drill and then install the hinge using 1/4" x 1/2"...

That depends on what you want to put back on. If you want a sleeve like is on there now, you have to disconnect ALL the wires and feed them thru the new sleeve. I cut the whole sleeve off, (using a...

Could be, check the fluid level, fill if necessary, and try again !

Top off the Master Cylinder and have someone pump the brake, like bleeding them, while you are under the trailer with a flashlight and look for the leak.

Well, I’ll be Damned !! Just got an email from them saying my shipment is on the way !!!

Not sure on the Ghost, but it's always been advised to disconnect the Trolling Motor when charging the Batteries. Either unplugging or using a switch or breaker to disconnect, that way if an...

20 some years ago, I had a partner that we fished 2 different Team Circuits. We switched off using each other boat. The way we worked it, Fill the tanks on both truck and boat before the tournament...

Go to a Pool Supply store and get the O-Ring Grease for on the Filter O-Ring. I lube mine every 5-6 Months. Stays on !!

A 220 outlet should be a different configuration. I'd check the outlet with a volt meter to see tho. Let the chargers rest for an hour of two, then try them in a different outlet that you know is...

Is it in the stowed position or the deployed position ? Mounted or just on the ground ? You may have to push DOWN on the mount and then pull on the cord.

Unfortunately this is what I'm finding out !! I thought they were a reliable company !