Thanks John, I'll take a look. ...kinda got side tracked over the last couple days.
Type: Posts; User: C3jim
Thanks John, I'll take a look. ...kinda got side tracked over the last couple days.
Thanks guys, appreciate the photo and link.....exactly what I am looking for.
I have an aluminum boat that I am mounting a transom mount type trolling motor on the bow. I have run battery extention cables from the rear mounted battery forward. I need a simple 2 stud covered...
Thanks. .appreciate the info.
Can someone tell me the maximum transom thickness this motor can be used on ? I'm building a bow mount out of 3/8" aluminum angle stock and I don't want it to be too thick. It will be looping over...
I'm in the process of replacing seals in my motor...got the two shaft seals out to start with. The old & new seals have a rubber coating on the metal part. When the originals came out. ..I noticed...
Thanks John, I was lucky and found the parts on ebay, hopefully they won't be as old as the ones in the motor now..we'll see.
Thanks, appreciate the input, I think I'll give it a go before I hit the lake with it.
Has anyone replaced the seals on one of these...the large case o rings & the two shaft seals. Just wondering the difficulty level of this and what to expect. My boat has been sitting for 10 yrs....
Sounds like the best option, wouldn't have to worry about it anymore.
I don't have a problem, just wanted to replace it before I do have one...it's an older Javelin. Sorry about the confusion. ..what I meant by correct is that the thread size and barb size match the...
Does anyone know if this would be the correct ASV to use with a 1990 150XP ...E150STLESB. The fitting is correct 1/4 NPT X 3/8 barb but can't find anything about what HP to use it with. Thanks
Thanks, appreciate the info
I want to install one of these on a 1990 Javelin with Evinrude 150 XP...would it be too restrictive for the fuel pump on this engine. Also. ..should the primer bulb be installed on the tank or...
I've got one...2 actually. ..didn't know what that system is called. I'll research it in the books and find how to test it. The oil in a couple is fluid not gummy. My boat has been sitting for a few...
Sorry about that. ..1990.Evinrude XP150. ..E150STLESB
Got the carbs off and replacing all the rubber lines. What are the small hoses used for ...not the primer lines but they are the same size. There are 2 sets of them. ..4 connections to the intake...
OK, that makes sense ...thanks.
I missed the hole when installing the lower unit. ...shift rod pushed the plug up and to the side. I cannot figure out where and how this thing was seated...can't see a groove etc. I assume it fits...
Sorry about the delayed response, finally got back to working on the pump & got it assembled as it should be. I think going by the instructions included with the kit is a little misguided. It said to...
Bought the kit...5001594. I'm at the part where instructions say install a "new impeller O ring" over the driveshaft and slide it down to midway of the impeller key to hold the key in place. The kit...
Appreciate the info, should be good to go on the carbs now...thanks.
Thanks for the info. Yes, I ordered the orifices along with the bowls. So the same float setup specs will work with these shallow bowls ?
Hi guys, first post on the forum....a lot of great info here. I'm attempting to bring my 1990 Javelin back to life after EXTENDED storage. I pulled the carbs and found as other posters that the...