Search:

Got the 80lb 52” mine has the same amount of play..

I have a vmax 24v 50ah that I’ve used a few times now and at only 21 pounds it’s been great for my needs. Spot locked for around 3 hours in light winds then spent probably 3 more hours on 5-6 on the...

No.. only if you want to use the jog feature.

My fluid was right at a year old and already looked terrible. Would definitely recommend every year..

I went with a single 24v 50ah on my boat I’ll update once I have some time using it.

Thanks :thumb up2:

Had my 8’ blade for a while now and the end of the spike is starting to split down the center in a couple spots. These are lifetime warrantied right? If so how do I go about getting a replacement..

i know looking at their 24v model.

Anybody running the vmax lithium batteries? If so how have they been performance wise.

I upgraded to the baystar setup on my pt 185 but I used the seastar hoses instead of the baystar tubing and I also upgraded to the baystar plus helm HH4514-3. The combination of the seastar hoses and...

Probably best if you find the lost red wire with said butt connector because now you have a hot wire loose in your boat that could cause a short. To answer your other question yes you could tie it...

Usually red “hot” goes on the center tab of the switch then just put blue on top green on bottom and if the controls are backwards just swap the green and blue leaving the red in the center.

Really interested to see how they perform

Only 30 amp continuous discharge is disappointing..

Can the GSL batteries be connected in series though?

Has minn Kota resolved the problem of these pieces cracking by possibly changing plastic materials or something? It seems like it’s happenend to more than a few people including me I noticed right...

Has minn Kota addressed the issue with many of the plastic cable covers going into the motor cracking? Just got my ultrex and when I took it out of the box sure enough the plastic piece was split...

Did the Sierra 18-4221 work for your older laser ii? I’m in the same situation right now trying to find the right one.

I acquired a pre flo torq laser ii prop pn/ 48-16990A40 20P. Does anyone know what thrust washer I need as I only have flo torq 2 thrust washer and they do not fit properly. Prop is going on a 2005...

Same issue on my pt 185 except I only have 1 pp and hydraulic plate. Been thinking of upgrading to Relion lithium batteries.. would save something like 75-80 pounds just for the trolling batteries...

I’ve also broken keys.. ran one over with the truck and broke the other in the ignition. I took the code on the key and found the key blanks on eBay for like $5-$8 if I remember correctly. Then I...

Glad I could help :thumb up2: and as far as fuse rating when I replaced mine after it blew it had a 30 so that’s what I put back in. 8 gauge wire is rated for something like 40 or 50 amp max fuse...

Had a similar issue on my boat and it turned out to be a 30amp main fuse on the battery positive cable about 12 inches from the terminal going to the fuse panel near the console. Sometimes it can be...

^i did this tapped them 5/16-18 and installed stainless set screws with blue thread locker and installed them until flush with the gear case. I can run my motor pretty darn high without losing much...

Revving the coin purse out of it!