I ran into the same problem a couple of years ago. They replaced my mega 360 and the problem still existed so I sent my Solix in for repair and the problem solved. You can connect directly to your...
Type: Posts; User: N9Phil
I ran into the same problem a couple of years ago. They replaced my mega 360 and the problem still existed so I sent my Solix in for repair and the problem solved. You can connect directly to your...
May everyone have a blissful fishing and boating year.
I have Dakota Lithium batteries and each comes with a single lithium battery charger. Lithium's are more expensive but they have several advantages over other battery types.
Since the 360 is now used for side imaging you can determine if the problem is in the 360 or the head unit you should hook your transducer direct to the head unit and now check if you have both sides...
I ran into the same problem a while back. I tried it on Side image and one side was also dark. They had me send the 360 in and when it came back it still wasn't right. I disconnected the y cable...
I have been out 5 times with my Mega Live running on a 30 ah Lithium battery for a total of 25 to 30 hours and no problems at all. This is not my permanent solution, this is my ice fishing battery...
Great pictures. It is exciting to finally get the Mega Live on the boat and get a chance to experience the excitement of actually seeing the fish you are fishing in real time. I have had mine out...
saved the screen shot on the Solix while on the water on Tuesday, Then I took a picture of the screen in my drive on Wednesday therefore my garage shows up and the reflection of myself and the boat...
Connected direct at this time. I probably wont connect to the ethernet box until spring time
That is the only one I have so far. I don't usually take pictures and post them but this time I took one and I thought that I would get some adrenalin going in Humminbird fans. Semper Fi to all...
https://scontent-ort2-1.xx.fbcdn.net/v/t1.6435-9/247184757_4227698157358662_756776608629089073_n.jpg?_nc_cat=101&ccb=1-5&_nc_sid=730e14&_nc_ohc=JPBTaWXsYkEAX9ToDZX&tn=K9mPL66WmAqr6rpP&_nc_ht=scontent-...
Time to compare all three. https://www.youtube.com/watch?v=aVgLu_fKgu4
https://www.youtube.com/watch?v=qQ1TqwwnZdA
https://www.facebook.com/kevinvandamfishing/videos/188053163297161
kybluebullet check your messages
I just upgraded both my gen 1 and gen2 Solix 15's with no problem. I have never done a factory reboot before upgrading and never had a problem. I use a 32K card that I always reformat before using...
I had the same problem last year. Disconnect your y cable and connect the original transducer to your solix then reboot your unit. You might have to do a factory reset in order to tell your Solix...
I ran into that problem with my old transom mount 360 and I found that it had not retracted all the way or had slipped down a little and it was dead. I pulled the unit down a little and then pushed...
I had the same problem with my Solix. I sent the 360 back and they found a bad transducer. When I received it back it was acting the same way. I also noticed that I had the same problem with my port...
Is it up and won't go down or down and won't go up? I ran into that same problem with my non mega 360 and I played with the transducer by pushing it up and down a little. I think that it was not...
You might try a reset of your solar network. When I got mine back it acted the same way until I did a factory solar reset.
First thing make sure the 360 is in the water so it senses the water and then with everything turned on factory reset your Sonar and then make sure that is turned on in your sonar screen. I then...
My mega 360 did the same thing. I hooked it direct to my Solix and no change. I then switched to lower frequency and problem went away. This eliminated the problem of the splitter cable. I called...
I received an E-Mail yesterday and my 360 is on the way back after they changed a bad transducer. Fast service and great support.
Another option would be to have another Solix transducer mounted on the boat and then you would only have to change one connection at the unit instead of two each time you want to switch out the 360.