Search:

I am no mechanic, but if it has grey fuel line change it all. The liner in the hose comes apart and will
collapse inside the hose.

It was all the Pressure regulator diaphgram. Small pin hole right on the edge of the metal. I guess it would let fuel into the air side when starting, but it would seal itself once engine ran and...

I was outside just looking things over due to me issue. I pushed the air side schrader valve and got fuel coming out under pressure. I then pushed the fuel side and also got fuel. I assume that...

https://www.instagram.com/reel/CiLNUVED33l/?igshid=MDJmNzVkMjY=


here is a link to instagram video

Ser #1B936285 I just looked it is 1000MCA. I guess that could be the issue. I seems to me that it is starving for fuel at start up but once the altenator kicks up the charge it runs fine. I am...

<1B936285> 2013 150 Pro XS. It is hard to start sounds like low fuel pressure. Once starting runs perfect. Was in shop and all pressures were good. Has new tracker diaphragm, fuel line, plugs,...

Dont hate because he is doing what you always dream of doing!

death only punishment that works

Congrats. Did the same thing 3 years ago after 25. Best peace of mind ever. Enjoy

small update. Tried boat after putting everything back in the boat. 1/4 tank of gas, full load of tackle and 3 "grown adults" i was getting 54+ and it was still going up when I ran out of room. ...

Got the 10" plate installed and started tweaking it. I think I need a little more bow lift and around 200 rpm. Thinking of trying a 23 or 22 Tempest Plus with a little cup. the 150 Opti Pro XS...

2nd owner but I did register with Nitro. Warranty till 2023.

I have been losing MPH and RPM on the 2013 Z7 with 150 Opti ProXs. Motor seems to be running right. I have gone from 55-59mph 2 years ago to 48 mph and only 5000 -5200 rpm loaded with two people...

Thanks for quick reply. I got one from Damon at Anglers Choice. Great service and the plate is unbelievable black Slidemaster. Did it help your boat out any

I am looking to put a 10 inch plate on the back. Will the stock Cables work or will i need to replace the cables. The Stock seem to be pretty long but not sure. Also those with a 10 inch on...

There is always more than what the media puts out, hit the pause button.

Do it. I rode with Duckett, Fukae, and Vinson, all good people. You will be amazed at how much work they are actually putting in each day of the event. They do not stop casting. Just be...

bravecto hands down

I bet they watch their backside during their next fight..

Mine never smoked or fouled any plugs just quits.

The first sign for me is when you start the motor it rev's high then slows down to normal idle. As it gets wrose it starts rev's high then starts dieing. Only gets wrose. The first one that...

Thanks to all who replied to this post. I was searching for anything that may have helped resolve this. Everything that Mercury had advised to do and check was done and still no luck.
...

This was the only one that ripped at the edge. That is what we asked Mercury to help with back while the motor was still under extended warranty and on the third valve. This motor has so few...

2013 150 Otpi Pro Ser# 1B936285

Let me start by saying I have posted on this matter before but it is still here. Here is the history of this battle with Tracker Valves

#1 Jul 15, 2017 ...

Seen 25 years of this stuff, You can not help these kids. Same outcome for them as the poor musician had to suffer.