Search:

Type: Posts; User: papatuel

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    33
    Views
    1,735

    My dealer installed Powermania charger and it has...

    My dealer installed Powermania charger and it has a lithium setting. So far works great. Get 99% charge on my Ionic batteries - 3 100Ah for trolling and 1 125 Ah for dedicated Lowrance units. It...
  2. Thread: trim wedges

    by papatuel
    Replies
    25
    Views
    1,745

    Installed 2 degree wedges on my 2021 CX21 and...

    Installed 2 degree wedges on my 2021 CX21 and picked up 4-5 mph pretty consistently. Definitely a bit more lift and did not negatively effect hole shot at all. Took 20 minutes to install by myself...
  3. Replies
    10
    Views
    1,677

    Maybe it's right on mine. 12" = 2 x 3.6A, 9" = 2...

    Maybe it's right on mine. 12" = 2 x 3.6A, 9" = 2 x 2.9A, and Active Target = 1.5A, so total is 14.5A max load. 125 ah would give about 8.6 hours to 0% if my math is right. In 6 hours of continuous...
  4. Replies
    14
    Views
    1,651

    I've loaded my 2021 CX21 on now about 20 times...

    I've loaded my 2021 CX21 on now about 20 times and found it's all about how deep your partner puts the trailer in. We've got it down now, but have to be out a lot further than my Rangers. Also,...
  5. Replies
    10
    Views
    1,677

    Hello CaymasRodney! Quick question - how long is...

    Hello CaymasRodney! Quick question - how long is your 125 ah Ionic lasting with your setup? I have the same battery with 2 - 12" Lives and Active Target up front and 2 - 9" Lives at the console. I...
  6. Replies
    3
    Views
    817

    I have the CX21 with BTM trailer and it has...

    I have the CX21 with BTM trailer and it has single disc brakes on rear axle. I have a Z521 Ranger that I'm selling and it has dual disc brakes. I towed the Caymas from Kansas to California and have...
  7. Replies
    38
    Views
    4,251

    I used Bob's black powder coated, but here's a...

    I used Bob's black powder coated, but here's a pic showing between JP and engine. Did it by myself by lowering engine onto a rubber block and supporting engine from lift points with forks on the...
  8. Replies
    39
    Views
    4,913

    I was able to get out today and run both props...

    I was able to get out today and run both props after installing Bob's 2 degree wedges. Set up is a CX21, Mercury 250 ProXS, no power poles, crank battery is AGM, 4 Ionic lithiums, took the passenger...
  9. Replies
    39
    Views
    4,913

    After we last spoke, I installed 2 degree wedges...

    After we last spoke, I installed 2 degree wedges last night and dropped the motor down to second hole from the top on my CX21. It was mounted in the 3rd hole from the top and felt like I couldn't...
  10. Replies
    7
    Views
    1,061

    Are you all using Bob's Machine 2 degree wedges...

    Are you all using Bob's Machine 2 degree wedges and did you get the wedge washers as well? Also, do you guys have a water pressure gauge? I thought Mercury came with it, but doesn't show up on my...
  11. Replies
    5
    Views
    825

    I also installed a dedicated 125ah Ionic and have...

    I also installed a dedicated 125ah Ionic and have 2-12" Lowrance with Active Target at the bow, but I used the existing 16 gauge wire. I have 2 - 9" Lowrance units at the console. You are getting...
  12. Replies
    10
    Views
    1,450

    My dealer installed all of my graphs (2 -12" on...

    My dealer installed all of my graphs (2 -12" on bow and 2 - 9" at console) wiring directly to clean power bus bar. I later installed a 125ah lithium house battery, removed the jumper wire (see...
  13. Replies
    7
    Views
    1,061

    I have the same setup without the power poles and...

    I have the same setup without the power poles and I get a little "slide" in fast turns, but no chine. I can't say at 70+ because I can't get that speed. I'm talking turns at 65-68 with no problem. ...
  14. Replies
    19
    Views
    2,003

    Here you go.....465900

    Here you go.....465900
  15. Replies
    6
    Views
    868

    Thanks for great feedback on what you've tried so...

    Thanks for great feedback on what you've tried so far. I am going to go ahead do the wedges. At our TOC a couple of savvy boat guys were telling me to try the 23 Tempest prop, that it will run a...
  16. Replies
    23
    Views
    2,335

    Thank you very much!! $50 is reasonable, I will...

    Thank you very much!! $50 is reasonable, I will get it listed tonight.
  17. Replies
    19
    Views
    2,003

    For what it's worth, when my Caymas CX21 was...

    For what it's worth, when my Caymas CX21 was being outfitted my dealer could only get a 52" Ghost immediately or I would have to wait another few weeks. So, I went with it. We had our TOC last...
  18. Replies
    23
    Views
    2,335

    Not sure where else to ask this question. I have...

    Not sure where else to ask this question. I have my new Caymas, but need to sell my 2016 Ranger Z521C. I listed it locally and on Boattrader. I looked but do not see a section on BBC to list boats...
  19. Replies
    6
    Views
    868

    I have a CX21 and based on the article below, I...

    I have a CX21 and based on the article below, I bought a 4-blade Bravo 1 FS 25.5 pitch. I just ran it for the first time today. Idle to on pad was incredible, about 3 seconds! Handling and...
  20. Thread: Garage Decor

    by papatuel
    Replies
    9
    Views
    1,115

    I just finished "dressing" my shop up. My wife...

    I just finished "dressing" my shop up. My wife called Caymas and told them I was outfitting my shop that houses my new Caymas and they sent her a really nice banner. She asked how much do I owe you...
  21. Thread: Caymas Cover

    by papatuel
    Replies
    10
    Views
    1,836

    463196 My dealer (Mid Kansas Marine) had Aurora...

    463196
    My dealer (Mid Kansas Marine) had Aurora Canvas https://www.auroracanvas.com make a custom cover for my CX21. He did not like the stock Caymas cover, especially for highway trailering. The...
  22. Replies
    21
    Views
    2,738

    I did not get the trailer step and wish I did. ...

    I did not get the trailer step and wish I did. Does anyone know if I can order one and install myself?
  23. Replies
    18
    Views
    2,194

    Good call on engine mounting holes. Mine is...

    Good call on engine mounting holes. Mine is mounted with two holes open, i.e. I can drop the engine two holes to get to the bottom. I think I am going to order the 2 degree wedges based on reports...
  24. Replies
    18
    Views
    2,194

    Great thread! I have a 2021 CX21, so will be a...

    Great thread! I have a 2021 CX21, so will be a bit different, but I'm curious on thoughts. I too have 4 Ionic + crank battery and load most tackle in the lockers on the back deck. I have a Ghost...
  25. Replies
    5
    Views
    978

    Thanks for replying! I feel potentially stupid...

    Thanks for replying! I feel potentially stupid on this, but what do call the “bow plate”? In my mind it’s the cover that goes over the hole in the bow deck where the bow graphs are mounted.
Results 1 to 25 of 44
Page 1 of 2 1 2