Search:

Type: Posts; User: TBOGEYBOGEY

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    124

    I have a passenger console from a 2007 200xl.

    I have a passenger console from a 2007 200xl.
  2. Replies
    1
    Views
    127

    bass boat trailer

    I am looking for a used dual axle bass boat trailer. I have 20ft stratos 200xl on a single axle and would like to find a dual axle.
  3. Replies
    2
    Views
    96

    thank you sir.

    thank you sir.
  4. Replies
    2
    Views
    96

    e-tec ignition/keyswitch

    2007 e225dhlsua 225 ho, My key switch has a dead spot in it and I am looking for a replacement. I can't seem to find the part number in any of the drawings. The key switch has 6 posts on the back...
  5. Replies
    1
    Views
    166

    tt

    tt
  6. Replies
    3
    Views
    295

    I run a 07 200xl with a 225 etec. I had trouble...

    I run a 07 200xl with a 225 etec. I had trouble with my set up initially as my tach was way off. I installed nmea network and get live engine data. I run a 27 renegade at 5500 rpm for 74mph...
  7. Replies
    1
    Views
    166

    2007 Stratos 200 console.

    Passenger console in good shape. $250.00.377675377676
  8. Replies
    17
    Views
    772

    I have done many boats and use weldwood Dap. I...

    I have done many boats and use weldwood Dap. I do small sections at a time and spray it on. When the carpet touches it is on....it will rip the rubber backing off if you have to peel it up.
  9. Thread: Seats

    by TBOGEYBOGEY
    Replies
    4
    Views
    445

    Lebroc

    Lebroc
  10. Replies
    6
    Views
    218

    Pm sent

    Pm sent
  11. Replies
    15
    Views
    743

    i dont have a trailer but I fish chautauqua lake...

    i dont have a trailer but I fish chautauqua lake as well and live in Jamestown.
  12. Replies
    13
    Views
    1,383

    cabelas

    cabelas
  13. Replies
    10
    Views
    480

    I have a 2007 200 pro xl that was taking some...

    I have a 2007 200 pro xl that was taking some water around the drain plug. I took about .5 gallons per hour.
  14. Replies
    4
    Views
    460

    trade for a renegade 13 1/2 x 23 (9/10) ?

    trade for a renegade 13 1/2 x 23 (9/10) ?
  15. Replies
    0
    Views
    101

    mercury 150 2.5 carb kits

    3 carb kits with extra carb gasket, paid 275 for the three kits, will sell for 60 each. if you are doing the carbs I would suggest all three.


    these are complete rebuild kits minus the float....
  16. Replies
    2
    Views
    181

    1999 nitro single axle trailer.

    There is a switch in the tongue of this trailer. Depress the detent and rotate for backup or leave for the brakes to work while driving.
    The switch is locked in the "free" back up mode. Anyone...
  17. Replies
    0
    Views
    149

    nx882 / Chris Bailey hydrofoil

    I have a 99 nx882, mercury xr6 spinning a 23 tempest. The boat the way it is currently set up has a 4-5 second hole shot ( livewells empty), two people, gear and 3/4 fuel. Runs wide open at 59.7...
  18. I went through the same thing with my 99 nx882 a...

    I went through the same thing with my 99 nx882 a few months ago. The wiring to my pumps had male and female connectors zip tied near the transom. The first thing I did was to check and make sure I...
  19. Replies
    15
    Views
    418

    I had the same issue years ago and it turned out...

    I had the same issue years ago and it turned out to be a ground from the ecu.
  20. Replies
    3
    Views
    182

    99 mercury xr6 OG870618 (reeds)

    I have 3 chipped reeds and I want to lap reed cages. Do I lap the seal from reed block to cage or the seal for the reeds themselves? Reed cages have a rubber coating where the reeds themselves...
  21. Replies
    1
    Views
    143

    99 mercury xr6 OG870618 (help)

    I removed the idle stabilizer and taped off the red/white and black/white from the switch boxes, is this correct? The switch boxes are jumped in the upper left corner.
  22. Replies
    8
    Views
    626

    I have done a bunch of boats and use weldwood DAP...

    I have done a bunch of boats and use weldwood DAP contact cement. They have an original fast cure formula that is awesome. this stuff is awesome.
  23. Replies
    10
    Views
    708

    I have done many bass boats with DAP and it is...

    I have done many bass boats with DAP and it is great stuff. As mentioned above, I pre-cut to fit. It is easier with the lids as all of the excess goes under and can be trimmed. I used the gel last...
  24. Replies
    48
    Views
    18,414

    Sticky: The one thing I haven't heard anyone make a point...

    The one thing I haven't heard anyone make a point on is the Holy Spirit. I witness alot and when I first started I had now idea what to say, but the Lord gave me words, scripture and encouragement...
  25. Replies
    16
    Views
    1,322

    I have a Nitro nx882 with a mercury xr6. I was...

    I have a Nitro nx882 with a mercury xr6. I was having trouble with the start and found a severely cracked enrichner line to the carbs. Replaced and it made a huge difference.
Results 1 to 25 of 28
Page 1 of 2 1 2