I'm not sure where to post this BUT I have a problem with my ignition key. My buddy tripped and broke mine off in the ignition cylinder. I need to replace it but I don't really wanna use an...
Type: Posts; User: broox
I'm not sure where to post this BUT I have a problem with my ignition key. My buddy tripped and broke mine off in the ignition cylinder. I need to replace it but I don't really wanna use an...
It's a 2012 z8, and I guess I meant for peak performance under ideal conditions
Does everybody run their boat at the full or "limited" position?
I'm just curious how everybody is trimming their Mercury. What I mean is: do you take it all the way to the trim limiter or just go by RPM and feel? That's what I've always done, just go by feel and...
I found a bushing/bearing...so now when I install it do I just need to put locktite on it? Or is there somethin special that I need to put on it before I put in in?
A couple days ago i noticed that the bushing where the tilt jack connects to my 200 pro xs had worked its way out a little so I persuaded it back in place. Well after a trip to the lake yesterday I...
^^^ that's EXACTLY what I had done...I took a closer look today and traced the wires back to the trim switch on the motor and actually discovered that the "up" relay was the closest to the front and...
Ok I'll try that
They actually both test good
i have a 200 pro xs serial #1B848201
today after I got off the water and went to raise the motor to put the transom saver on the trim just kept going up on it's own. I took the leads off the...
Ok thanks...I'll send him a PM
What weight carpet did you end up going with? I am getting ready to replace mine.
I have a 2012 z8 and am not sure how the pump out feature works on these boats. On my dads z7 I know there is a valve inside the livewell that you pull out to get them to pump out. My z8 has two...
Does anybody have a connection where I can buy one?
Mercury 200 pro xs serial #1B848201
I have a trim gauge that is not working, it is pegged past the up indicator. I have replaced the gauge and am now wanting to replace the sender itself. I am...
Not tryin to hijack the thread but yes even with ALL the wires off the back of the gauge it's still pegged all the way on up
I have this same trouble on my 200 pro xs...gauge pegged at full up...
I just bought a 2012 z8 with a 200 pro xs...just took it out for the first time...it's got a 24 fury in it and the prop shaft is 3 3/4 below pad...there was literally no gear in the boat and half...