Search:

Type: Posts; User: Mark Wendler

Page 1 of 15 1 2 3 4

Search: Search took 0.01 seconds.

  1. PM sent

    PM sent
  2. Replies
    2
    Views
    223

    PM sent

    PM sent
  3. Replies
    4
    Views
    371

    PM sent on #3-6.

    PM sent on #3-6.
  4. Replies
    12
    Views
    612

    Text sent on Gen 2 STX.

    Text sent on Gen 2 STX.
  5. Replies
    12
    Views
    738

    I do the same thing. Saves the cover from any...

    I do the same thing. Saves the cover from any damage.
  6. Replies
    5
    Views
    964

    PM Sent

    PM Sent
  7. Make sure that any recalls/service bulletins on...

    Make sure that any recalls/service bulletins on the motor have been addressed. When I picked up my new boat, weeks later I got a letter from Mercury thanking me for my purchase and stating that I...
  8. Replies
    16
    Views
    637

    I have been using the Vmax XCA31-1400 for almost...

    I have been using the Vmax XCA31-1400 for almost 2 years now and am very pleased with it's performance. (I was previously running the Duracell AGM) The only side note is that the mfg recommends...
  9. PM sent on Monitor.

    PM sent on Monitor.
  10. Same here.

    Same here.
  11. That was actually the first part of the equation...

    That was actually the first part of the equation for me. But, lowering alone wasn't enough so it also took some rearranging.
  12. Uh, I found just the opposite when going to...

    Uh, I found just the opposite when going to lithium. The first run, after removing 3 group 31 AGM and replacing with 2 36V 40AH LiFePO4, my Z520C lost all it's bow lift. I had to move a lot of stuff...
  13. I have a set for an 01 2.5L 200hp EFI. Also known...

    I have a set for an 01 2.5L 200hp EFI. Also known as O-Ring heads. Not willing to split though.
  14. Replies
    2
    Views
    370

    I used isopropyl alcohol to remove any wax before...

    I used isopropyl alcohol to remove any wax before I applied the new decals. I don't believe you want any wax between the adhesive and the gel coat.
  15. This stuff ^^^ works!!

    This stuff ^^^ works!!
  16. Replies
    15
    Views
    2,885

    I am running the VMax XCA31-1400 for my cranking...

    I am running the VMax XCA31-1400 for my cranking battery. They recommend charging at 20A minimum with a bulk charge voltage of 14.5 to 14.9 volts. The charger I finally settled on for the job is the...
  17. Yep, had one go out. Worked for 2 years before it...

    Yep, had one go out. Worked for 2 years before it died.
  18. Replies
    12
    Views
    1,099

    Lol #11 is variable, dependent on age... When you...

    Lol #11 is variable, dependent on age... When you are 20, #11 never enters the mind. When you are 40, you consider the ramifications, but since you are a card carrying member of the man club, you...
  19. Replies
    12
    Views
    1,099

    Pull the center out of the passenger seat back...

    Pull the center out of the passenger seat back (velcro'd in place)
    Remove 4 large screws from the passenger seat back
    Pull passenger seat slightly forward and lift
    Place passenger seat off to...
  20. I am using one of theses relays in conjunction...

    I am using one of theses relays in conjunction with one of the accessory switches on the my keypad. It's way overkill, but I feel that there won't be any voltage drop with it.
    479714...
  21. I have rented these cabins, but they are closer...

    I have rented these cabins, but they are closer to the Highport Marina area.

    http://www.thecabinsonhighportroad.com/
  22. Replies
    4
    Views
    299

    I concur!

    I concur!
  23. Replies
    28
    Views
    3,235

    PM sent

    PM sent
  24. Replies
    7
    Views
    429

    But, charging aside, it will work in an emergency...

    But, charging aside, it will work in an emergency situation. Correct?. I mean, if you have 3 lithiums in a 36v config, and one craps out in a tournament, and you have a spare AGM available... You...
  25. Replies
    20
    Views
    1,229

    Did you put all 3 100AH batteries on the port...

    Did you put all 3 100AH batteries on the port side of the bilge, on your Z520C, or do you have 2 on the port side and 1 in the middle?
Results 1 to 25 of 375
Page 1 of 15 1 2 3 4