Search:

I have a 1996/97 Yamaha proV 200 Hp - model# P200TLRU. my lower unit needs replaced, can anyone tell me what years/models this is compatible with incase I find a used one?

Thanks!!

Original Raker 24’ in good condition.
PM if interested I can send pics

$300

or would trade for 26 Raker

you’re absolutely right!

There’s a nipple behind the carbs between the throttle bodies? Had a dry rotted rubber cap on it, anyone know what this is? And would this being open cause it to run poorly? 1997 225hp Johnson venom...

Where are the recirc valves and how do I maintenance them?

Idle RPM if tach is accurate is about 800, 650-700 in gear

Don’t forget to check that center flywheel magnet.

Hi guys,

I have been fighting this thing for a couple weeks now and still haven’t been able to figure it out
its a 1997 Johnson Venom i recently bought that had a new power head a few years ago...

oh okay, I was under the impression there was suppose to be a clear sleeve around the black roller

after doing some reading aren’t I suppose To have a clear piece over this throttle linkage roller?

453924

Ok guys I could use some help with starting to troubleshoot an issue. I just put this motor on my boat (1998 Johnson Venom 225). I got It put on and everything connected nicely using the CDI adapter...

Thanks I appreciate it!

Hey guys, I’m sure im not the first one to do this so I’m hoping someone can offer insight. I had a 1988 looper 200GT Johnson on my boat till I blew a hole through the block last week. Anyways I...

Makes sense, I was Mainly measuring for some kind of consistency across the pins and it was all over and not all of them read anything. Replaced timer base, still no spark....very frustrating

Thanks! The timer base output tests bad according to the CDI manual, it however doesn’t exactly read the same the as the original OMC manual. Good news everything else tests good clearly, so Im going...

Will do! I take it these are known to have issues

Yes sir it’s a 1988 200 GT. Has small black push button kill switch. One of the first things I did was pull the safety lanyard off and manually push the button and tried to start it. Do you meant...

Ok so I pulled the flywheel and ran a serious of resistance checks on everything i could think of. Power pack and all coils check good, stator is low end of the range but checks good, neutral switch...

Hey guys I could Use your help.
I have a 1988 Johnson GT 200 that had been running flawlessly, I took It to the lake and ran it some yesterday without issue and then at the end of the day noticed...

Thanks!

Noted, I’m not familiar with this hull or motor yet. I know my nitro likes it high @ 3.5, I’ll bring my tools to the lake with me and move it till it works the best

I just Picked up a new 25’ Tempest prop today for the ol girl. Just have to find a hub kit to fit on the Johnson. Curious to see how it will do.

Can anyone link me to the hub kit I need to be able to run a mercury Tempest on my Johnson 200 GT?
thanks!
Jake

Yes it has a jack plate I set It @ 3.75 below pad to start. Have not had it on water yet may have to lower it back down right away I dont know yet lol

Hi all,

i have a late 88 Stratos 189V with a strong running Johnson 200 GT, 6” jack plate, currently old worn out shooter prop ive been in the process of restoring it. I only Had it on the water...