Search:

Hey finworm, was it the one of the wire from power pack to coil? I have looked at all the wires and didn't see a problem but I'll give it another closer look when I get time. Thanks for your input.

I agree with intermittent problems being the worse. seems like they only show up at the worse time possible. Plugs look good, clean and not much wear on electrodes, they had not been replaced in...

Thanks For the reply ChampioNman. If all the grounds are good and you were going to try a new part what would try first. I have replaced the plugs (QL78YC gaped @ .030). I was thinking of getting one...

Well I just got home from the lake and the boat ran like a Singer sewing machine. Last two trips it hasn't missed a beat. Two trips before that it ran on five cylinders or less several times. I shut...

I have a 2000 225HO Johnson (carburetors) that suddenly develops a dead misfire. Seem like it is running on 5 cylinders. It only does this after it is warmed up. If I shut it down and let it cool...

I have been having the same problem with my 2000 Johnson 225HO, It starts and runs good until I stop and fish for an hour or so, then it bogs and dies when I start to move. If I rev it up a couple...

If its not to much trouble could someone post or e-mail me this procedure or give me a link to where I could get it? Thanks again, Bulletpilot

Hi Seahorse, Thanks for the reply. I can't answer all the question you ask, I have no idea what the temp of the heads are, the idle adj. screws and the sync and link are all at the factory setting...

Hey Seahorse you have any suggestions on the stalling problem my 225HO has got? Thanks, Bulletpilot

OK here's an update. I replaced the OMS, man are those thinks high or what $346.00, and it still has same problem, I rebuilt the carbs, and still has the same problem. Anyone have any ideas what to...

Found it !! Thanks again. http://www.bassboatcentral.com/smileys/smile.gif http://www.bassboatcentral.com/smileys/smile.gif http://www.bassboatcentral.com/smileys/smile.gif

Thanks for the info Championman. I have tried the choke but it didn't help. Is that number (5007420) BRP's part number, I looked on there web site and could not find it. I found a number for a fuel...

Hello Everyone,
I need some help with a 2000 225HO Johnson. This is a carb engine. It runs great most of the time, but some time it will stall when I hit the throttle to came out of the hole. It...

Thanks Rusty,
Bulletpilot

Thanks Rusty, That's what I was afraid of, What's one sell for?
Thanks again,
Bulletpilot

Hello everyone,
I need some help with a oil leak. This is a 2000 225HO Johnson carb motor. It is leaking oil from the fuel pump, there is a square sensor looking thing with four wires that bolts to...

Thanks for the help. I couldn't find the parts anywhere so I found brushes and springs at a starter and alternator shop. Got it all back together and it works great.
Thanks again....

Hi, I have read this message board for a while but this is the first time I have needed to ask for help. I have a 2000 HO Johnson, the trim motor quite working. The seals must have failed and let...