Thanks.
Type: Posts; User: BigRanger21
Thanks.
Thanks, I’ll check them out.
Looking to buy new or used Ultrex 80lb 24V in 45” or 50” shaft. Could pick up around WI or ship.
Top Speed with your setup?
Hi,
Where and what shop have the best prices for new motor? Looking for 200 pro XS 4 Stroke.
Thanks,
Peter
6” jackplate ship to 53051.
Hi,
I have a solix unit and can’t figure what trolling mount bracket it need. Do anyone know what model of transducer mounting bracket the solix use?
thanks!
Steering teleflex pro trim Dual trim tab or single trim tab. Thanks. I’ll call ranger
Hi guys,
Planning to install hot foot to my z518. What is the recommended throttle cable that is needed? Single or dual trim tab?
This will save me time and make sure I order the right length....
Thanks guys!
Hi guys,
Where are you guys mounting your electronics on 2012 Rangers? I was thinking mounting on the dash but it’s blocking my view. Let me see some photos of your electronics mounted. What mount...
Thanks! Going with precision.
Hi guys,
I’m looking to install 2 helix 9 on my dash. Wondering if anyone has done it and will it work. Also, what brand of bracket?
I was looking at the PROcise dual mount.
Thanks.
Pm me the price. Thanks.
Wow! That sucks!
Yes I have.
Looking to buy a 2010-2014 z518 with 200hp. (Prefer single console)
Message me location, prices, electronics, pictures, and motor hour.
Any one have the cover off their Talon? I need to see how it look like.
Install everything back already. Should of took some pictures. :(
Pretty easy, not that much to it. Motor, electronic board, cable and lots of cable roller. Lol
Hi,
I drove with the Talon down and the cable inside the talon got stuck. I took it apart and now I'm trying to wind the cable back onto the motor bracket coil. Anyone know the best method?
...
Perfect
thank you
Hi,
When running my 1998 Mercury optimax, there are oil dripping out. I heard its normal, but just wanted to confirm. Check out the photo.
Thanks!
With the over heating light on. I'm assuming it's the air handle and air compressor temp sensor.
Any my ideal how to test these? What are the ohm reading across both wires?
Temperature light on gauge.
Thinking it might be a temperature sensor going bad. The alarm beeps even when the motor is not started.
I did pull a fault codes at the local dealer.
See...
Fried the check engine light. On The front of the motor, by the lower of motor, there are two wire. It came loose. Re-connect and clear the check engine.
Still need to fix the over temperature...