Search:

Just wondering if anyone else is having problems with an overheat issue. My unit indicated overheating and then it turned down the brightness.

Thanks for your response. After looking at the oil drain part, it seems to me that it would be very easy to over tighten. I would think that the engineers would consider adding a stop ring to the...

I was wondering if I am the only one that is having a problem with leaking oil from the oil drain. This is the second time I’ve had my motor serviced and each time I get it back the oil drain leaks....

Would you mind sharing what equipment you use?

What is the deepest effective depth that sidescan can be used?

I got the SC 1000 speedometer to show The speed from the GPS by connecting the yellow wire to the white wire with the blue stripe and connecting the blue wire to the blue wire with the white stripe...

Thanks for the information. I’ll try it and I’m sure it will work. Thanks again.

How do you wire the lowrance carbon line to a mercury SC 1000 speedometer gauge so that it reads the GPS speed?

Hi, could you give me a price on a 10 inch action jack shipped to 33950

Thank you; Thank you. The primer bulb moved to the point where the arrow was pointing down and by moving as you said solved my idle problem.

Is a tracker valve something that can be done at home or do I need to take it to a dealer.?

Motor will not keep running at idle. Will run fine above idle speed. Motor is a 2014 with 1100hrs. and just had a 100hr. service. The primer bulb will not get hard when squeezed. Will change it...

Would a slightly bent skeg on a torque master gen 2 affect rpms? My guess is it shouldn't but not sure.

thanks for your response.

Is there a way to test a coil to make sure it is working properly?

Thanks Mike. Is the MM the same a the Smartcraft SC 1000 speedo and the SC 1000 tach.? The speedo has blue/w white stripe and white/w blue stripe wires. The wires have a NMEA 0183 tag. I...

Thanks for your info.

Can someone explain or tell me where to find how to wire between my motor and hds 9.

Just got done running. Was able to turn 5900 rpm's at 59mph. and that's with full fuel (50 gal.). The problem was a bad low pressure pump in the vst. The guys at High Performance Specilities in...

Finally found out why I couldn't get full rpm's out of my 250 pro xs. The motor had a bad low pressure pump. Will be changed out tomorrow.

Thanks for the info.

Is the screen on the low pressure pump or on the high pressure pump?

Thanks Savage.

I read an earlier post about a 250 pro xs loosing power and it was caused by a clogged vst screen filter located in the vst housing. I checked mercury's parts catalog and can't seem to find where...

Tried to find in the parts cat. where the vst screen is in the fuel pump housing. I assume you don't mean the fuel filter. Can someone tell me exactly where to look.