Search:

Thanks much for the info!

I'm planning on upgrading from my 296TF to a new 496TF. I do not have a Jack Plate on my 06 296TF and have never thought I needed one. With that said, can anyone suggest whether or not I would need...

Is it true that Charger is going through major changes and moving forward will only be building the 198, 206 and 210 hulls? Has anyone had any recent experiences with Charger? I understand Charger is...

Don, thank you AGAIN! The reset worked as you expected. The gas used reset to zero, but I expect I can reset that once I run it again.

Thanks FeFanatic, no additional cut wires and connections are all tight and clean. I think you are correct, it is not communicating with the motor. So, I spliced the wire on the prior sender and...

Thanks for that info Savage. When I turn the power on the RPM, trim, speed (which typically does not work) and other readouts keep moving, Ex, the RPM goes up to 3000-4000 drops to zero and then back...

My SmartCraft Gauge was reading the incorrect trim level. After trying to recalibrate a few times I found the trim sender wire was broke. While trying to recalibrate I threw most of my readings off....

Thanks much for the additional info Pro-Hunt. It is helpful!

Pro-Hunt, nice looking ride. What year is it? I'm looking at a new Pro XS, Raptor, Solix Graphs, and Minn Kota Ultrex Quest. Any thoughts or ideas on set up or Charger options on the boat?

Thanks for that note!

I'm glad to hear about the Quest, because I am in the market with a new boat. My greatest fear is in having a version of the Ultrex that squeaks. I've heard them on friends boats...... it's a no...

I am considering Solix graphs. I prefer to go back to In-Dash at the console. Anyone have a Solix In-Dash at the console.Wondering if a 10" can fit in the dash. Raptor vs Talon..... I plan on...

I own a 2006 296TF. I'm looking for any info anyone has on upgrading to a new 496TF: I am planning on H-Birds (probably Solix)/Ultrex Quest TM, I only know about the Marketing info I read. I...

:thumb up2:

Can I order that switch from you?

Thanks Don, the sensor needed replacing as well because it stopped reading at one point. Can I just replace the switch or do I need to replace the entire shifter

I still have intermittent trimming down issues after installing a new trim sensor, relays and calibrating. I am only having the issue at the shifter and not with the front trim switch or trim switch...

I was able to add approximately an ounce of fluid. Hopefully, that makes a difference.

Thanks Don, what might be causing the trim range to be limited?

Still having minor issues with trimming down. Day 1 of 3 fishing it took time to trim down at 1st launch. I had to use the front trim switch to get the motor to trim down. It worked day 2 and 3. The...

Thank you Don!

Don, being they are a polarity-reversing system does that mean that I might damage the the sensor by only changing one? I have 1 used back up in my boat for this weekend, but have ordered 2 new ones....

I recently changed my trim sender cable on y Merc Opti 200 (serial#1B274474) after my dashboard analogue gauge stopped reading. It now reads fine. However, the DOWN trim only is intermittent now. I...

Wow!!!

Cool!