had the same problem replaced the primer bulb problem gone
Type: Posts; User: ctmatz
had the same problem replaced the primer bulb problem gone
new price
bump
can you use a transducer for a gen 3 helix on a 1199
new price
pair of are rod pods used come with mounting hardware. 200.00 pick up only shipping to costly. Would be willing to meet within a hrs ride
SOLD SOLD SOLD
unit works great 45 inch shaft built in transducer troll perfect on motor also has steel prop t&h prop nut mount has lift assist 250 plus shipping will meet you if you are close
SOLD
trolling motor has been rebuilt works great was used as a back up comes with mount 200 plus shipping will meet you if close
Installed new key switch and harness still does the same runs when key is held in start position
Yes
Switch has 2 yellows and both have 12 volts
Model is vxtrlz
Have a 2001 150 wont run unless you hold the key in the start position
any help would be greatly appreciated
Looking to buy a livescope for the front of my boat. My question is it fairly easy to set up or do you need a phd.tks
will a none mega 360 work with a 1197
complete lower unit off a 1998 150. It is a counter rotating. comes with both props. props are a 25 pitch. 20 inch shaft
500.00
2016 521 with a 250 pro xs. Any suggestions on a good prop to use. tks
Thank you
Have an ultrex with a 4 pin plug for the transducer what cable do I need to connect to my 1199 tks
i bought the as-ec-qde adaptor it his 8 pins the connector on the ultrex is 4 pin what other adaptor do i need tkd
what do i need to get to connect my ultrex i to my 1199 so i can use it to follow contour lines
tks for the help
Just installed an ultrex I pilot. I have 1199 and non mega 360 can I connect the ultrex to the 1199
Installed a 360 The mount is the one that flips to tighten Is there a way to lock this so someone with sticky fingers can’t just cut the wires and flip the lock Tks
Thank you