Instructions on how to bleed the under-cowling oil tank - from the BBC Merc 3.0 L forum:
...
Type: Posts; User: taeheel2az
Instructions on how to bleed the under-cowling oil tank - from the BBC Merc 3.0 L forum:
...
Could well be a inadequate or failing battery, inadequate state. Could also be be a bad connections somewhere.
A gasket above or below the adapter plate in the midsection may have failed. Not particularly difficult to replace the gaskets, but tedious - remove the block, then the adapter plate and drive...
When I begin to have a drop in performance. Usually shows up first in starting a little slow or rough. If I ran WOT would probably notice a difference there.
Lot more fun this go 'round, isn't it?
I hate that for him - a good guy.
I also applaud FLW and BASS for being sticklers about their rules.
CatFan's right. Not difficult.
Summer heat prevents pollination a lot of places in the US. Other times, just shaking the bushes is adequate. BYW, tomatoes are self-pollinating - no insects needed.
Me, I wouldn't run it again until I got it to a certified tech and find out what's going on.
One thing for sure, you retried way too often. That buzzer sounds a warning for a reason, and when the...
The Chowan River basin and Albermarle Sound are easily within that range. Launch off hwy 13 near Murfreesboro, or Hwy 17 at Edenton. Fish the mouths and a mile or so into the larger creeks.
My...
Well, I'll find out. Due to brain cramp on the part of the operator (me), I destroyed the one I just put in - I've ordered another.
Considering the average shop hour rate is in the $100 - $120 per hour range, I'd say you gave your customer quite a deal.
I had a TR21 with a Yammie deuce. After I got it tuned in, with an average load it did 61 - 63 at 5400 rpm running a 4 blade..
Definitely gonna leave a mark.
Thanks, I'll try recalibrating. Wiring is connected as it was when it worked - yellow to yellow, blue to blue, black to black.
Model 1-225D73FY
SN 1B387675
3 wire digital sending unit
Getting a Trim Fault the first time I trim up or down after turning on the key. Trim and tilt work just fine.
Chronology:
For about a...
Dishonesty. Didn't get caught.
Just out of curiosity, do you ever criticize the government for being deceptive and dishonest?
Thanks!
I've always had a choice to enlarge or shrink the page content on IE (8.0, I think). Used it last week, to enlarge a parts diagram. Now the window is stuck in the enlarged state, and the litlle box...
I've watched it done hundreds of times.
If he doesn't know how to sit on command, teach him to. He gets no food until he obeys you, every time, no exceptions.
On an Opti especially, a loose connection yields only bad things, many of which give wierd symptoms. Me, I'd test it one the water and confirm whether or not the problems's still there before I spent...
Seals may or may not be bad. For sure you're overgreasing. If the seals and bearings are installed and packed correctly, they use virtually no grease. One or two pumps a year are all they need....
A cable, a "junction" instrument (MercMonitor or speedo or tach where the cable connects), gauges, gas & oil connector cable (optional).
:smile: :smile: