Unbolted the motor holder and was able to move it enough to access the pin and knock it out.
Type: Posts; User: Ranjo
Unbolted the motor holder and was able to move it enough to access the pin and knock it out.
I just moved it far enough to see that there is a rod insert into this hole that runs from one side to the other, but I can’t move the unit to clear this hole. Is this supposed to come out without...
Yes
Probably used incorrectly terminology. Number 13. It looks like it just sets into the shaft but mine seem to be into both the tilt shaft and the main body. Can I drive them back into the tilt unit...
I have a 1992 Yamaha 70hp motor. I need to replace the tilt unit (not the trim) cannot figure out how to get it out or at least move it so I can remove the two pins holding the bottom of the unit. I...
Turned out to be bad gauge. Voltage at back of gauge was the same as that at the battery. Ordered new gauge
Found the fuel gauge issue, bad ground wire at the gas tank. Not sure what’s going on with the volt meter, could be bad
I’m having issues with my dash gauges. When I turn the key on the gas gauge pins to empty, volt meter pins to 16 and the tach doesn’t register at all when the engine is running. Could this be a...
It appears to be more than the fuel gauge. The fuel gauge doesn’t register correctly when the key is off and pins to empty when the key is on. Also, the tach doesn’t register and the volt meter pins...
Yes. Could it be losing its ground when the key is on?
Fuel gauge registers with key off, but start the motor and the gauge goes to empty. Any thoughts?
Thanks
Just FYI, this starter is 25 years old
I had it in the shop last fall for the same issue. They said it was a grounding issue and fixed it. None of that has changed
I found a couple of questionable ground wires at the key switch, so I replaced them. The starter would then spin but not engage the flywheel. I pulled the starter and checked the brushes , they are...
Can’t figure it out, time to take it in.
I thought maybe I could just replace the power wire and ground going to the switch using the new fuse box. The rest of the wires should remain the same?? I think
It shows no power to the starter side of solenoid. I’m beginning to think I may have wired something wrong. I just finished remodeling my 1995 princecraft deck boat and installed a fuse box under the...
Pulled starter out and connected ground to battery and hit the positive side with positive battery cable. Starter engaged. Do have 12 volts at solenoid, but have not checked at solenoid output. Is...
E115TLEOR
Yes, yes and yes
Have a 95 Evinrude 115 motor. Start just clicks when I turn the key. So far I have done these things to try and fix it
1. Replaced battery cable
2. Recharged starting battery (fully charged)
3....
No excuse for sending out their product that that condition. None
Good luck finding it. I emailed the company and it wasn’t available within 250 miles of my place. Apparently they don’t care if they sell it or not.
I moved on and used weld wood contact cement.
Hope your experience with BassCat goes better than mine. I recently purchased 20 feet of the 24 ounce. It arrived in such poor condition it was unusable. It was creased about ever 2’. They didn’t...
Need advice on adhesive to attach closed cell pad to aluminum deck.
Thanks