Payment sent. Thanks.
Type: Posts; User: bigbasser54
Payment sent. Thanks.
I will take it. PM sent.
I am currently having the same issue. Motor guide will tell you it needs to go to a dealer for circuit board replacement, they refused to send a replacement board directly to me which I consider...
Please delete
AC Delco iridium's...watch out for counterfeits
It will chine walk some trimmed out, just learn to drive through it. I run a 6" jackplate at about 2.5" below pad, plenty of water pressure. Should see low to mid 70's with an avg load. 26p...
I get this occasionally.
Try restoring the sonar defaults, go into settings...sonar...restore sonar defaults. Should fix it.
Unit mounted on trolling motor, running 6.0 software update. 2-D Sonar will cut out and lose bottom when deeper than 12' of water. Less than 12' it works flawless, deeper than 12' it loses bottom...
I am in a similar situation, looking to get a new trailer delivered from Tenn to NY. I found this company who will do it for about $1000. https://www.shipmytrailer.com/
If you find a...
Ran it today with fresh set of plugs installed with cowl removed, misfire gone. Thanks all!
Gaps were all within spec. Going to swap them all out and see if anything changes.
Thoughts on the plug conditions? #2 and #5 look fine to me. #1& #3 have a roughly circular light spot at the top of the insulator. #4 has dark staining on one side and also a few carbon/metal...
368448
368449
368450
368451
368453
368456
I typically use the rubber hose method for plug #6. Removing the cowlings adds time...guess these plugs are so delicate it's worth the effort....
I'll pull plugs and report back. Thanks all for...
New plugs before this season so 4/2019, probably 5 hours on them. I can pull and inspect for cracks in the porcelain.
Hi Don,
Got my low rpm miss back, misses just above idle to about 1000 rpm then clears right up. Last time with this issue (5-6 years ago) was an air injector on #4 I believe.
My fuel system...
Bad design, i would weld plate on the outside of the pin to minimize slop and fully box the bottom of the 2" channel
I have a complete set from a 2003 tr21, (pre springs). 2 bucket seats and a middle. Let me know if you would be interested in them. Good condition just need to be recovered.
The TR hulls run pretty flat at WOT. Sit at 4000 rpm and a small amount of trim <1/8th. Then accelerate and trim up. You should be able to feel the bow lift as your speed and rpms increase. If...
How much trim at those rpm numbers?
Get a 26p tempest plus, if u can find a B&Bd one with some cup even better. PVS plugs drilled to 3/8". Keep heavy stuff like anchors and tools in rear compartments. Should be able to jump it out...
I did this on my 03 dash. I started with the cheap eBay stuff thinking it is the same as the 3M di-noc. The eBay stuff had very little stretch and was difficult to impossible to stick on tight...
How are your 08-09 seats mounted to your boat? Are they on seat slides, if so are the slides useful? I am retrofitting a set of 08 seats to my older TR-21, trying to decide on slides or direct bolt...
Since you'll be in Cooperstown, hit Otsego lake. Its right there and has a good bass population
Thanks for the replies, carpet knife is working well. Might try the soldering iron in the tight spots.