Search:

Type: Posts; User: apdriver

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    17
    Views
    398

    Took my boat out today and off the trailer at...

    Took my boat out today and off the trailer at idle, water temp was 72, went from cold engine to thermostats opening at 134 degrees in 2min.30 sec. I think I’m just getting impatient. Does this seem...
  2. Replies
    17
    Views
    398

    I did not disassemble the ones I replaced. I...

    I did not disassemble the ones I replaced. I tested per the service manual instructions and they tested good. When they opened in the boiling water per the service manual instructions, I brushed the...
  3. Replies
    17
    Views
    398

    Ok. I’ll do all this. Try to make a movie but I’m...

    Ok. I’ll do all this. Try to make a movie but I’m technically challenged. Just for discussion purposes, there’s no trash in the thermostats, I just cleaned the strainer with little run time and I...
  4. Replies
    17
    Views
    398

    yes sir, I did.

    yes sir, I did.
  5. Replies
    17
    Views
    398

    yes, sir. I believe it does. It’s not drips but...

    yes, sir. I believe it does. It’s not drips but it’s not full dump hose either. It’s a steady stream though. Maybe 5%-10% of dump hose or so. Do you think I’m just getting impatient waiting for the...
  6. Replies
    14
    Views
    561

    Thanks Don.

    Thanks Don.
  7. Replies
    14
    Views
    561

    I replaced the TPS and the three bolts holding it...

    I replaced the TPS and the three bolts holding it in place seemed like they had a bit of loctite on them. Wee bit hard to remove and I could see something on the ends. May have been just a little...
  8. Replies
    17
    Views
    398

    Just replaced both thermostats along with the...

    Just replaced both thermostats along with the TPS, lever and cover for an intermittent high idle. Before putting it all back together, I decided to test the thermostats while the dump hoses were...
  9. Replies
    17
    Views
    398

    Thanks Savage. I’ll just replace them both.

    Thanks Savage. I’ll just replace them both.
  10. Replies
    17
    Views
    398

    Water pressure at idle is 3.7. Pretty good stream...

    Water pressure at idle is 3.7. Pretty good stream of water coming from both dump hoses before thermostats should have opened. Is that normal? Oh, I ran it in a barrel not on muffs.
  11. Replies
    18
    Views
    966

    Only real variable is temperature. I had some...

    Only real variable is temperature. I had some super tech 2 stroke clump a long time ago. Not trying to steal the thread but it does happen.
  12. Replies
    17
    Views
    398

    Poppet valve/Thermostat

    250 ProXS
    Model 1251P73KD
    Serial 1B962763

    Merc Monitor installed so I watch my temps before getting on plane to make sure I come up to temp and the thermostats are working properly and open. In...
  13. Replies
    9
    Views
    397

    I buy out of bulk barrels at a dealer. It always...

    I buy out of bulk barrels at a dealer. It always smells like ammonia too. DFI is full synthetic.
  14. Northstar 31

    Northstar 31
  15. Replies
    8
    Views
    468

    If you have ever run one of these, you would know...

    If you have ever run one of these, you would know they are a lot more fragile than the original aluminum skeg. They are only held in place by two small diameter bolts that are drilled into the...
  16. Replies
    14
    Views
    561

    Thanks for the replies. I’m going to just double...

    Thanks for the replies. I’m going to just double check the hotfoot, throttle stop, linkage,and lubricate. Water test it one more time and if it’s still acting up order a TPS from Rhonda. Thanks...
  17. Replies
    14
    Views
    561

    Just looking at the service manual, it says that...

    Just looking at the service manual, it says that the TPS position can be monitored with the CDS. Gives voltage specs at idle and wot. By scan tool, I’m thinking you mean CDS. I don’t have one of...
  18. Replies
    16
    Views
    454

    Northstar 31series AGM.

    Northstar 31series AGM.
  19. Replies
    14
    Views
    561

    Is there any way to test the TPS to see if it’s...

    Is there any way to test the TPS to see if it’s operating correctly?
  20. Replies
    14
    Views
    561

    Intermittent High Idle

    250 ProXS, Serial#- 1B962763. Serviced last May. 280 hrs Total time. Last two times out have experienced intermittent high idle. When I shut the motor down and restart, it will idle fine. To prevent...
  21. I paid 3800.-, IIRC, about a year ago for a...

    I paid 3800.-, IIRC, about a year ago for a used/rebuilt and that was probably a good deal from a Canadian dealer that was just across the border because of strong dollar and exchange rate. I believe...
  22. Replies
    4
    Views
    361

    Usually there’s a couple bolts behind the caliper...

    Usually there’s a couple bolts behind the caliper that holds it on the wheel assembly. With these axles there is a bit of history of the bolts backing out and letting the caliper loose and causing...
  23. Replies
    4
    Views
    198

    I don’t think so because the bulb would collapse...

    I don’t think so because the bulb would collapse as the motor pulled a vacuum on the fuel system.
  24. Replies
    4
    Views
    198

    Problem with DF50 shutting down

    I have a 2011 DF50 with 100 hrs on it. Iím having an issue with it shutting down while cruising which I thought was probably a fuel delivery issue and started troubleshooting at the common issues. I...
  25. My schedule and Basscats schedule NEVER coincide....

    My schedule and Basscats schedule NEVER coincide. I would love to drive a few of their larger models. Lynx, Jag.
Results 1 to 25 of 186
Page 1 of 8 1 2 3 4