I bet you have either some grit imbedded in the spring seal or it's worn out. If you follow the line up the side of the engine you will see where the black plastic one-way valve is clamped inline. ...
Type: Posts; User: moymurfs
I bet you have either some grit imbedded in the spring seal or it's worn out. If you follow the line up the side of the engine you will see where the black plastic one-way valve is clamped inline. ...
Yes, you would need the merc connector under there. A junction box is merely a splitter. You can get them with multiple outlets. If memory serves me correctly, when my setup was analog I had a...
Ran mine off the J-box at the helm. Never disconnects.
Need 1 = Order 3 :rolleyes:...very fragile for the environment they are exposed to.
How would he possibly find out if the previous owner had used an additive?? He's had the motor for "3 years" and performed multiple oil changes.
You never said how many hours were on the motor. If it's a bunch, you get to the point of other worn components....= total repower. If it's not much, and you want to keep the same hp, then a new or...
From what you said it sounds like Mercury IS honoring the warranty, just going the cheapest route. I repainted my own lower unit where paint was gone using Merc's primer and paint. It still looks...
Do yourself a favor...buy 2 or 3 of them. They are fragile.
Just curious, what did you find out about the issue?
Don, does Mercury supply its certified service establishments all the "special tools" they will need or does the dealership still have to purchase them ? Just curious.
"Top Tier" has nothing to do with high volume/frequent turnover if that's what you are inferring.
here is an explanation of it:
If a station is branded as being Top Tier, it means their...
1st, electronics should not be on the engine battery side. They are drawing while you are trolling plus what Catfan said above..you will have a loss just from the cranking. Do any electronics shut...
The part is the part. It's from the same factory all the assembly steps and torque settings are already done. It's the externals the service dept installs. You will get a motor that performs like...
:thumb up2::thumb up2:
It is possible to strike something and the blade not hit it. If you are taking possession of a new motor, repower or new boat, it is crucial that you look everything over very carefully. I have...
I'm in Moyock, NC 27958 (willing to pay reasonable shipping of course).
Looking for the Enertia (NOT ECO) 20p 3 blade RH prop. Not interested in props that are "close' in pitch/diameter.
Merc...
Top it off with your 87mix and run it. It's already pretty "diluted" if your math is correct.
So I have no idea if it's related but the facts you relay are ALL the same as mine were except hours.
2016 150 4stroke, 7 hours (yes 7). Under the platinum service plan. Gurdian mode. " Low oil...
Don, what is the neon green stuff Merc uses? Is it a dielectric grease equivalent? found it in my plug boots.
Is it zinc? If so, it shouldn't be painted in the first place.
Same symptoms?
:thumb up2:. Thanks, I was thinking that would be the "best" scenario.
2016 150 4stroke ser# below. (Engine starts and runs great!) So everything I read in the manual and searched in old threads says the engine is to be connected straight to the cranking battery. ...
Ideas are speculation that does you no good. It's a dealer trip for facts for you.:popcorn:
Is there any way to draw a fluid sample from the lowest part of the gas tank? Do this on your driveway after the boat has been sitting level overnight. Your symptoms sound exactly like mine when...