I pulled my lower unit on my 1996 175EFI to change the water impeller, all went to plan until I tried to put it back on. The lower unit never got any closer than about a 1 1/4” from seating, I can...
Type: Posts; User: Hayden scott
I pulled my lower unit on my 1996 175EFI to change the water impeller, all went to plan until I tried to put it back on. The lower unit never got any closer than about a 1 1/4” from seating, I can...
I have a 1996 ZX190 with a 96 175EFI turning a Yamaha 25M at 5950rpm. I just got this prop today and ran 66.8mph with the prop 3” below pad, this is just myself and a 1/2 tank fuel, I am really only...
I have an old MG 775 24/36V, the variable speed has stopped working. The motor still operates fine it's just stuck on full speed. When looking for parts I am having a hard time finding any for it,...
I pulled the canon plug, it was a little dirty so I cleaned it and spread the prongs just a little and added dielectric grease. Checked under the cowling for any loose connections and couldn't find...
I have a 175 EFI that dies in rough water. On days with a 1.5' chop or less it does just fine, but any more than that it will take off just fine but after a few hard waves it will just shut off. I...
I have a 175 EFI that dies in rough water. On days with a 1.5' chop or less it does just fine, but any more than that it will take off just fine but after a few hard waves it will just shut off. I...
I tried out a friends 25p tempest plus, we were on a very small lake so I really didn't have much room to air it out. The boat ran 68.7 mph at 5900 rpm, never lost water pressure, rooster tail looked...
Aright, so I think I'll find a tempest, what size should I try?
The water impeller is not the problem, previous owner just replaced it, I think the 4 blade trophy is giving me to much lift. Just trying to figure out what prop I need.
I just recently purchased a 1996 skeeter zx190 with a 1996 Mercury 175 EFI, turning a 23p trophy plus at 5800. First time I really tested the boat I started to loose water pressure about half way...
I just recently had the same issue, take a fairly large ratchet strap from the back pedestal seat post to the rotor. Have someone follow you and go slow, i went 50 miles at about 35 to 40mph....
