Is anyone running an Atlas 12” on their ZX190?
pros and cons?
Type: Posts; User: skeeter1984sf
Is anyone running an Atlas 12” on their ZX190?
pros and cons?
Thanks!
I have a 2017 Skeeter ZX190 factory stock manual plate 12" setback should I use the same setback with an atlas hydraulic?
Finally decided to pull the trigger on a new Skeeter. The 1984 star fire restored is a great boat but does not compare to the ZX190.
http://www.bbcboards.net/attachment.php?attachmentid=270887&stc=1
Wat kind of midifications will they do?
also forgot to note no rooster tail
So I have finally been able to run this boat without a temp alarm. new numbers as follows.
7.5below the pad
5200 RPM 54 mph
water pressur 25+psi
hole shot is great had trim just a little bow up...
Ran it today after all the work listed with no issues guess I. cheated myself out of a new e tec 150 h. O.
thanks for the information I never knew that.
1985j150stlcos
had a temp light over 3800 rpm. Replaced deflectors and ran it WOT for 5-8 minutes no alarm. Dropped back to 3000 ran a while no alarm. Dropped to 1800 ran about 3 min temp alarm....
Will do thanks!!
Installed water deflectors last knight and torqued heads to 228 inch pounds which converted to 19 ft lbs and have small water leaks around head gasket areas when first started. After running up to...
1985 J150STLCOS
Had an overheat conditon at any RPM over 3800. Cooled and tested to narrow down. Got to the house and pulled the heads off and discovered the deflectors blocking one side on the...
Thank you sir ill try to start over this weekend
I have a 1985 skeeter starfire 160 fish/ski
currently running the folowing.
Johnson150gt
14.5 x 20 raker prop
t&h manual 6" set back jack plate
Started at 4" below pad and kept moving till...
Does anyone have one of these?
28 0386686 TEMPERATURE switch Not Available
1985 150gt J150stlcos
Are the temp switches still serviced?
Thanks Championman!
Thanks Championman!
Also can I install an actual temp guage to this system? Also what is the recommended running temp at Idle?
1985 j150stlcos
Upgraded this engine with new v r o and system check harness and all components. Saturday after running WOT for about 4 minutes come off plane and running about 1800 RPM the water...
Go to a website for Fiberglast development www.fiberglast.com talk to the tech people they are greet.
Nevermind I found what I needed
Well thanks any way founsd an old steering adapter chart and the 0173680 is confirmed as rhe correct paralell steering adapter.
Can some one please upload a picture of dual cable steering setup off of a 1984 or close to it with a v6 150gt johnson or evinrude
0123606 part # is on this engine and is shown as part of the kit part# #0173680 is this where the second cable mounts? BRP calls it a dual cable tilt tube kit.
part #0173680 is this the correct adapter for my engine?