One other thing. I had to drill holes in the jackplate. Not sure what needs to be done with other types of plates.
Type: Posts; User: Tpop
One other thing. I had to drill holes in the jackplate. Not sure what needs to be done with other types of plates.
I did mine on the jackplate. CMC hydraulic
https://www.transducershieldandsaver.com/
On a strictly financial basis I would say no.
Does anyone know if LakeVu has the same lakes as Navionics?
1997 150 EFI sn 0G478636/ 1997 Basscat Sabre
Does 14.18 volts while running at full throttle signal a properly operating charging system?(voltmeter connected to battery)
Looking for a pn for a...
No ECU available to borrow. Most everyone I know runs aluminum with four strokes.
Makes perfect sense. I'm wondering why starboard and not port.
I'm still fighting the no pump/key on issue. Engine died last Saturday and as of today I still have no pump with key on.
Can I ask the reason for checking for spark on starboard side? How does that tie in to the ECU/fuel pump issue?
I can jumper the negative terminal to ground to get the pump working but engine will not start. Carb cleaner sprayed into air intake does fire the engine. Where does the 12 volts originate to the...
After engine quits and fuel pump does not come on at key-up I have 12 volts on each terminal. Are you saying to measure across the positive and negative terminal?
Ongoing problem.....1997 150 EFI sn 0G478636.
Engine dies and will not restart. No high pressure fuel pump with key on. Pump will run when jumpered but engine still won't restart. Will fire with...
Assuming the charging system is working properly what would be the charge voltage at idle and WOT?
1997 150 EFI sn 0G478636
Did the ECU end up being bad? I sent my ECU in for repair but I'm still having the problem.
Can a bad stator or switchbox cause the high pressure fuel pump to not turn on when key in on position?
1997 150 EFI sn 0G478636
1997 150 EFI s/n 0G478636.
Here's my problem. Engine will quit intermittently but only while idling. Once it quits it will not restart. High pressure fuel pump will not come on with key in on...
Snapshotmd,
I'm no expert but your problem might be a powerpack breaking down. Having the problem when engine is hot would make me be suspicious of the powerpack/coils.
My symptom is engine runs fine at WOT but after idling for a few minutes the engine quits and will not restart. High pressure fuel pump will not turn on with key in on position. Seems the ECU is...
Merc 150 EFI sn 0G478636
Looking to purchase a high pressure fuel pump kit. Is pn 8090881 the same as pn 809088T-1 or 809088T?
Merc 150 EFI s/n 0G478636
What's the trick to removing the filter off the High pressure pump?
Might have to replace high pressure fuel pump along with some other VST parts. Should I pay extra for the OEM parts or are aftermarket parts worth the savings?
1997 Basscat Sabre/1997 150 EFI/sn...
What is involved in cleaning the VST and what parts will I need to reassemble the unit?
1997 150 EFI s/n 0G478636
I talked to Simon before sending it in. I wanted it upgraded and figured while there I might as well get the drivers repaired/replaced.
A over/under voltage seems like a definite possibility. Would...
I was told to post this here instead of "stock" forum.
Does anyone know if there is something in the VST that would disable the hi-pressure pump circuit? Engine starts and runs great for...
Does anyone know if there is something in the VST that would disable the hi-pressure pump circuit? Engine starts and runs great for approximately 20 minutes then shuts down. It will not restart. High...