I'm getting another new reed plate tommrow so I will let you guys know what happens. Thank you
Type: Posts; User: Turner326
I'm getting another new reed plate tommrow so I will let you guys know what happens. Thank you
Fuel does hold at 15psi. It's the air that drips to 0.
Hey don thanks for the response. Sorry for not filling your directions to a T but the compressor is off now. When the compressor is hooked up it falls rapidly. 0psi air and 15psi fuel with in 15...
Ok so I put the new o-rings and new reed plate in. I put it all back together and had my buddy do a oil prime on it with his software. Same problem. Air and fuel still low. When I turn it off it...
It didn't look like it. Just some corrosion around the o-rings. I feel like I could put the reed plate back in with new o-rings but I would rather just do it right the first time and not do it...
Ok took the compressor apart. Reed plate o-rings are shot and reed plate is a little corroded. Going to replace the reed plate and o-rings. Piston and cylender look perfect. Is 835088A10 the...
Ok sounds good. Hopefully everything looks
Ok. Are the o-rings reusable or should I just order o-rings before I pull it apart? If I find dirt should just clean and reassemble? Or should I just get a new reed plate? Thanks
Ok so I just got don't doing more diagnosing. I did the key off and honestly I forgot what my results were cause it's been a long day. All I can tell you is that air and fuel just fall steady and...
Ok I will check them tomorrow and let you know what I find. Thanks are there known problems with grey injectors?
Thanks for the response don. The injectors are the gray ones. Are they problematic? I cannot do a acceleration test right now because the boat is on the trailer. I could probably get it in the...
I also notice a quick plume of smoke from the prop on start up. The port motor does not do that
Yes that's what I meant lol. Should have been more specific. Would I know if my reeds are broke? Would I hear anything or would the air be blowing back through the compressor intake? Thanks
Set my compressor to 103 psi??
I also notice the book say .043 for the spark plug gap. Is this still accurate? Thanks
Twin optimaxs serial #2b362048
Just put the motors on the boat after some work to them. Seem to run great on the muffs and I ran it in the water for about 5 minutes cause it was so windy. ...
It was at idle when the motor was turned on. But I will keep this in mind from now on. Thanks Don
Thanks for the reply savage. I just looked through my manual and saw the procedure. I will work on it and report back.
This is what I'm slightly confused about. From what I understand the tps works with the PCM to controll idle speed. So if my throttle is out of adjustment would it really affect the rpms at idle? ...
Forgot to mention that after it was at 1000 rpm at idle I shut it off and restarted it and it was back to normal. In and out of gear a couple times and it was still back to 600 in neutral
Twin optimaxs 200s. Serial#-2b362048. Put the boat in for the first sea trial yesturday on these new to me motors. Started them up and they ran perfect at idle. About 600 rpms. Put them in gear...
Thanks don. Does that plug in somewhere on my main harness or does that plug into the smart craft j-box? Thanks
I should also mention these are just basic fuel gauges. I have 4 tanks on the...
200 optimax
Serial# 2b362048
Finally got these put back together and installed on the boat thanks to the help of everyone here. Only got them started on the barrel and they seem to run great. We...
Thanks don
So I'm hoping to get this back together this weekend. After seeing all the post on here about torquing the power head bolts I'm a little confused. Should I follow the manual on this or has this...