Search:

Type: Posts; User: wcs69rat

Page 1 of 6 1 2 3 4

Search: Search took 0.00 seconds.

  1. yam911, Thanks for the info

    yam911,

    Thanks for the info
  2. 2004 225 OX66 tilt trim sensor effect on oiling

    I have a question regarding whether or not the tilt trim sensor can affect oil injection. My buddy was at a local marina to pick up a new trim sender cam (clamp) today and the mechanic told him that...
  3. Replies
    20
    Views
    1,425

    Sorry to hear about your issues...I've been...

    Sorry to hear about your issues...I've been chasing similar problems with my 225 OX66. It appears that unplugging the rpm reduction switch on mine fixed my initial problem but the O2 sensor and plugs...
  4. Replies
    2
    Views
    290

    Probably the tilt / trim relay. I had the same...

    Probably the tilt / trim relay. I had the same issue on my OX66. If it's the relay, I would recommend going back with an OEM relay. I tried the cheap route and had two aftermarket ones last about two...
  5. RL552, As mentioned above, I unplugged the...

    RL552,

    As mentioned above, I unplugged the the RPM reduction switch that CJ1 suggested. The terrible vibration went away but it still had no power and would not get on plane. I found the O2...
  6. Replies
    6
    Views
    337

    Yam911, Thanks for the diagram. I believe...

    Yam911,

    Thanks for the diagram. I believe that the last time I checked the input voltage (red wire) it was right at 5 volts. I did not check it yesterday. I’ll try to do that this week sometime.
  7. Replies
    6
    Views
    337

    SELOC manual

    SELOC manual
  8. I had not read the last two comments regarding...

    I had not read the last two comments regarding the reeds when I installed them but I just installed a set of Chris Carson reeds and stuffer kit. The stock stainless ones appeared to be fine but I...
  9. Replies
    6
    Views
    337

    2004 OX66 VMAX 225 TPS voltage VX225TLRC

    I was working some other issues on my motor and thought I would check the adjustment of the TPS voltage while I was at it. Mine was a little low; it was at .41 volts. My manual says to set it at...
  10. CJ1, Is the draft tube the same thing as the...

    CJ1,

    Is the draft tube the same thing as the "dog bone" ? If so, it is clean and there is no build up at all on it.
  11. Those plugs were fairly new and all had spark,...

    Those plugs were fairly new and all had spark, however, I did install a brand new set the other day when I replaced the O2 sensor. I purchased the original set that had been in the motor for a couple...
  12. RL552, I haven't forgotten about updating...

    RL552,

    I haven't forgotten about updating you if I get my issue fixed. I disconnected the RPM reduction switch that CJ1 suggested and took it out to run it. It still would not get on plane and...
  13. 2004 OX66 225 Chris Carson Reed Valve Stuffer Kit Question

    I ordered a new set of reed valves and a stuffer kit from Chris Carson Marine for my 225 OX66. My question is this: in stock form, there is a gasket beneath the reed block. When you install the...
  14. Replies
    11
    Views
    710

    Like 201PRO said...don't run Yamalube. It cokes...

    Like 201PRO said...don't run Yamalube. It cokes up stuff like crazy. I have switched to Pennzoil XLF.
  15. CJ1, Will do. Thanks.

    CJ1,

    Will do. Thanks.
  16. Replies
    25
    Views
    1,525

    Drewtick, Thanks, will do. I believe I spoke...

    Drewtick,

    Thanks, will do. I believe I spoke with you on the phone some months back, but my lead acids are almost new...I would like to swap over now, but may end up waiting a little while. I was...
  17. Replies
    25
    Views
    1,525

    I hope you guys don't mind me posting on the...

    I hope you guys don't mind me posting on the Phoenix forum; I'm usually hanging out on the Yamaha and Gambler forums. However, I was interested in this thread on Lithiums. Do any of you guys that...
  18. RL552 Will do

    RL552

    Will do
  19. The only light I have on the tach that is...

    The only light I have on the tach that is flashing is the temp sensor indication that has flashed ever since I installed that digital tach a couple of years ago. It seems to be independent of the...
  20. 2004 OX66 225 will not get on plane or turn over 2000 RPM's and vibrates

    I have a 2004 225 OX66. When I took the boat out a couple of days ago, it idled fine through a very long no wake zone. Then it was very sluggish getting on plane and top speed was way down. Top end...
  21. Replies
    4
    Views
    338

    Bellbass, Thanks for the info. I managed to...

    Bellbass,

    Thanks for the info. I managed to find it in an old thread. Sorry I just saw this message.
  22. Replies
    5
    Views
    449

    Thanks, Found a guy on this forum with an OEM...

    Thanks,

    Found a guy on this forum with an OEM unit with very little time on it. Hopefully we can get the logistics worked out.
  23. Replies
    6
    Views
    251

    21XDC, Thanks. I appreciate the info....

    21XDC,

    Thanks. I appreciate the info. Yourself as well as several others on this board always seem to help guys out with the knowledge you have. It is much appreciated.
  24. Replies
    6
    Views
    251

    21XDC, Thanks for the info. Forgive my...

    21XDC,

    Thanks for the info. Forgive my ignorance; what causes the loss in bow lift? Is it the lower gear ratio or does it have something to do with the shape of the lower unit?

    Thank you.
  25. Replies
    4
    Views
    338

    I found the posting that I was originally looking...

    I found the posting that I was originally looking for, but if anyone else has one, let me know. I may be interested. Thanks in advance.
Results 1 to 25 of 132
Page 1 of 6 1 2 3 4