I have a 2008 DF200A and thought I needed new control cables. I pulled off the shift cable to see if it was the throttle or shift cable and when I did, it the cable moved very easily. I then tried...
Type: Posts; User: frogbite
I have a 2008 DF200A and thought I needed new control cables. I pulled off the shift cable to see if it was the throttle or shift cable and when I did, it the cable moved very easily. I then tried...
Thanks, found them at Lowes with a smaller hole. I need to do the other side as well, but may wait until they are completely gone, since Brian suggested that an access panel would need to be cut in...
On my way there now.
Got to it. There are 4 screws on the port side carpeted panel. The 4th one was hard to locate, but eventually got it and got the panel off. Thanks all!!!
Thanks Brian, are there screws hidden the carpet? I am guessing there must be then.
-frogbite
Yeah, finding a bushing should not be hard, even if I cut some rubber sheets. Getting the rail out is the issue mostly. I dan not find an easy way to take the box out. There are screws all around...
Hi all,
On my 2004 ZX225, the rubber bushings under the factory grab bar on the passenger side have rotted away. I can get to the front mount easily but looks like some surgery will be needed to...
Thanks Dave. There is also a question about the max number of people that can be in the 2012. Looks like the 2014 may be 8, but the 2012 maybe less than this.
All,
I have a buddy looking at a used 2012 Triton 220 Escape. He lives on the Banana river and will use the boat in the flats, to pull skiers and occasionally take it out into the open water if...
Yep, I am in total agreement. Since the white wire runs to each light it is guaranteed a ground. Since that same white wire is connected to the trailer itself I would think would make the trailer...
DABS, I actually tested it by putting the negative from the motor start on the tongue and with this the reverse lights would come on with the positive to the blue lights, hence not the ground to the...
I just went through this with my Skeeter trailer. For me it was intermittent so I purchased a new cutoff valve, which it turned out I did not need. I noticed that I could put the vehicle in reverse...
I wish him a speedy recovery.
Now I have to clean my keyboard. Beer everywhere.
Is the 1993 rated for a 225? I would suspect that there may need to be some rigging modifications after that many years but I have not done this before. There is quite a big weight difference as...
Oh, and if anyone was wondering. Ethanol sucks!!!!!!!!!!!!!!!
Went through what seems like the same thing on my 04. In the end it was two bad injectors and I can not speak more highly of Brucato. The basket filters are cheap and easy to replace so it would...
I would take the screens off and check behind them.
Boy does this need to be a sticky. If you search on my id and trim you may find a thread from a month ago or so where this was discussed and someone actually posted the Yamaha part number for the...
My 2004 was a Bass Federation Nationals boat. When it went back to Skeeter to have a defect repaired they took off all the Bass Federation markings. One thing to note about these boats, and...
Oh, this is front wheel drive so it looks like the rear tires are brought to the front and crossed normally. From tirerack.com it says you can do a X pattern as well on front wheel drive. I will go...
Yes, I rotate my tires on my truck every oil change per the manufactures guidelines. On this vehicle it is every other oil change basically. I will rotate them and check for a difference. While...
Yes, they feel a bit choppy. Especially the front ones which have been on longer.
I purchased a new to me vehicle with Cooper CS4 tires. It looks like the tires were never rotated and I have the paperwork from the tire place the original owner got the tires from. Two were put on...
Yes, it is OX66, says it right on the cowling. VX is OX66.