Appreciate it jgiljr!
Type: Posts; User: McBass
Appreciate it jgiljr!
Thanks much Bplank79. Very helpful. I didn’t think the bulkheads seemed strong enough. Any idea how thick the fiberglass is there?
mcbass
Howdy,
has anyone installed a noco and did you mount vertically on what would be one of the left rear bulkheads?
Thanks for the response ksdavis1!
Thanks much Jersey, appreciate it!
Hi guys,
Has anyone done this swap? Any pearls of wisdom to share please.
Thanks
Folks, I have a 2004 vintage 200SP with 200hp Optimax. What are your opinions on use of a motormate instead of a standard transom saver? OK on these older boats?
-thanks!
John
I haven’t run my boat since early October. Unfortunately tank is less than a third full. Was going to pump out the old gas. Should the filter on my Opti handle any potential water? Filter is less...
Hi,
Could you do me a favor please and point me to the announcements. Thanks much
Hi,
Wondering if this has happened to anyone and how you repaired.
thanks,
John
Thanks Savage
Howdy,
I removed my prop and found the spring portion of this outer seal laying on the shaft. Has anyone ever seen one of these become detached from the seal before? I drained my fluid and there...
Guys,
Before I start yanking out batteries, can someone confirm the location of the starboard recirc pump. Is it the one most accessible, near the access plate?
-thanks,
Appreciate it. I think I've got one of those. Good idea...
Thanks much. I'll look around!
Guys, my passenger side rod ramp retaining strap has gone missing. No idea...It's similar to a T-H Marine Rod Tamer. Any idea where I can find one?
-thanks,
John
Guys, has anyone done this upgrade on a circa 2004 200SP? Any advice would be appreciated!
My fishing partner has a '98 ZX21 with a tilt steering wheel. I was using the steering wheel to pull myself up and out of drivers seat. it appears I damaged the tilt. Can't get it to lock any longer...
Guys, My friend is attempting to diagnose the problem with his Flow-Rite system. It’s in a ’98 Skeeter ZX210. He purchased the boat used, so doesn’t know if this is the original system. It’s a System...
Thanks much Rollo
Hey Ed. Thanks much!
Hi guys,
Any idea where I can find a like replacement? It's for my 2004 200SP.
-thanks,
John
Thanks jimscia...
RiverRatMD
that was boneheaded. It's a 200 Optimax.
thanks
Mcbass
Not too much in the setups category. Looking to get a Tempest prop for my 2004 Procraft 200SP. I'm guessing I need a 26 inch pitch, but I'd appreciate your input.
-thanks much,
John