Search:

I'm looking for a mercury 250xb fuel ecu part number 83004615T. Thanks

Thank you ill check it out

I have a set of 300 promax injectors out of a 98 model. I pulled them out of an intake I bought. What would be a good asking price for these? I'm shure they will need to be flow tested or cleaned to...

No not yet I havent found a set

Yes they are and I'm gonna use my 225 efi injectors and just swap the throttle plate out. I can still use the 300 reed plate right? I was just gonna swap the whole plate out

Alrighty that's fine I just wanted to make shure it wasnt gonna have a negative effect

I recently broke a reed (carbon) in my 1998 225 efi. I have a set of dual stage reeds what differance would I see between the two? Any help would be appreciated

That's what the guy told me it had ive never filled it completely but its a big tank. How much are you asking for the 10in plate

Well I got the chime out of it come to find out my hyd steering had a pin hole in the line and was leaking I'm running 74.6 solo at 6000 and with two people and half tank of fuel (65 gal tank) I'm...

Ive had 8 norriscrafts and this is my second triton this isnt normal chine the entire boat walks about 2 ft to each side and countersteering like you would for normal chine doesnt effect it when...

1998 tr20 with a 225 mercury. Right now boat is holding 18psi water pressure with a 26p tempest plus. Holeshot is a bear if the motor isnt trimmed just perfect. Boat is chine walking extremely bad at...

I just rebuilt this motor it sounds and runs great but when shifting into neutral it stumbles and sometimes dies any ideas on what could cause this? It does not do this going into forward or reverse

its not been worked that i know of

I havent ran anything with it yet im rebuilding the 225 tomorrow when my parts arrive gonna start breaking it in this weekend was just gonna go ahead and set the plate height while i had it in the...

And what speeds should i see out of this setup

I recently purchased a 1998 tr20 single console hull that im rigging with a 1998 225 efi mercury. I realize that the boat is only rated for a 200 but i already had the 225. Anyone have any advise on...

I'm putting my 99 optimax powerhead onto a 2008 mid section

I bought a 25in mid 1999 225 optimax and have located a 250 optimax 20in mid that's newer does anyone know if there has been any changes in the mid section that it wouldn't work? I believe he said it...

It's in a large tub of water it has a low water pickup lower unit and the pickups are completely submerged

I replaced all the gaskets under the housing also

Replaced the water pump in my 1998 225 optimax due to low water pressure. I still have low water pressure and noticed today I'm loosing alot of water around the top of the lower unit. I know the...

I just purchased this engine and did not receive the controls can someone tell me exactly what controls I will need to run this. My old controls were for a 200 efi and I was told they won't work any...

Thanks guys and I definitely will I'm putting it on my center console Norris craft tomorrow

I have a 225 Ficht ram 3.3l it makes 248hp on a 21xlv center console Norris craft. I'm trying to get the boat set up but with it being center console and sitting so much farther to the front of the...

Can anyone tell me what the actual hp is to the props haft on my 1980 225 mercury mod v