Thanks
Type: Posts; User: Whiz
Thanks
I got the heads off and clean the new pins are in. My next question is do.I use gasket sealing compound on the head gaskets?
I pull the head and there was debris around the deflector pins. I have new gaskets and pins on the way. Is there anything special about replacing the deflector pins?
Water pressure is 6 to 8 at idle, I used the whole kit and replaced the relief valve and springs. Overheating was the issue I was chasing. All pass problems was fixed. I will pull the head and let...
I switched the thermostats around and the portside is running hotter?
What do you use to flush the motor and how do you do it?
I have a 1990 XP 150 VE150SLESB I got a solid horn alarm and it had been several years since I replaced the water pump, so I put in a new water pump and new thermostats. I hooked up the muffs and...
1990 150 XP VE150SLESB
I'm replacing the thermostats and noticed the washer the pressure valve slides into on one side is warped comparied to the other side. To replace it the head has to come off,...
How do I transfer Eagle fish elite 480 waypoints to my new Garmin 73SV ?
Thanks for your help
Just spin
Checked the fuse and it was good.Put the jumper cable on the + post and touch the +post on the starter and it spun.
Tried that and yes
Backed the boat in the water, turn the key motor started and ran couple seconds and died( cold blooded always does that) next time I turned the key nothing. The Battery is new, terminals are clean...
Thanks
I have a 1990 XP 150 Evinrude model #VE150SLESB how many cranking amps battery should I have?
Sounds like fun
Wawasee
6.0 from Barbee chain Rat-L-Trap
Thanks Champioman, that makes a lot of sense because it was running good down the channel and the channel was very shallow and the motor was trim high.
Went out today and put the muffs on and the boat fired up and idle good. I could put it in gear and it would run. The the roller that Champ talked about is intack. Maybe it is the power pack since...
Took it to a mechanic and he said the problem was the crabs needed rebuilded and the recirc. pump needed a new check valve. He called and said had it running good in the shop when the timer base on...
It starts fine in the water, will it run different out of the water? I have to keep the throttle forward about three, four inches to keep it idling, as soon as I move it back to put in gear it will...
ChampioNman...If it is the power pack, would it be an intermittant problem? I thought it seemed that the primer bulb was a little soft so I had my partner squeeze it when I tried to go and that...
1990 Evinrude XP 150 Model #VE150SLESB Serial #R08534817
I had a problem this weekend. The motor would start and as soon as I would put it in gear it would die. I ended up having to get towed...