Search:

Type: Posts; User: gac1218

Search: Search took 0.00 seconds.

  1. Thread: Ranger Trailer

    by gac1218
    Replies
    6
    Views
    1,011

    Called the dealer and they said Ranger won't...

    Called the dealer and they said Ranger won't build one for anything older than 2008. I have an07. So far, Venture, Load Rite, ez loader Aluminum trailers are to long and won't fit in my garage.
    ...
  2. Thread: Ranger Trailer

    by gac1218
    Replies
    6
    Views
    1,011

    Ranger Trailer

    Looking for a trailer for a Ranger 521vx?
  3. Replies
    2
    Views
    266

    Well, I figured I was going to take it to the...

    Well, I figured I was going to take it to the shop, so I grabbed the prop and put some pressure on it and i heard a little pop as it freed up and now it works. If a little piece of the magnet broke...
  4. Replies
    2
    Views
    266

    Ultrex prop is locked up

    While fishing today I hit a shallow sandy bar and the prop stopped working. Steering works, spot lock turns, shear pin is not broken. I tried it at all speed settings. Turned it off and back on. The...
  5. Replies
    7
    Views
    725

    I replaced the cable and the empty/fill switch...

    I replaced the cable and the empty/fill switch and all works now. I think the end of the cable sitting down on the bilge gets dirty and every time it is operated it pushes dirt and grim into the...
  6. Replies
    7
    Views
    725

    Livewell valve not operating.

    I replaced my flow rite valve because the other was leaking. When I put the new one in It still leaked a little, but I couldn't turn the empty lever, and broke it off. I took the cable off and the...
  7. Replies
    15
    Views
    2,248

    I have told you he did all of that despite...

    I have told you he did all of that despite weather or not my terminology is correct, but your not hearing me. Obviously you don't have an answer or a suggestion to what it could be or you would offer...
  8. Replies
    15
    Views
    2,248

    I don't have precise pressures. I wasn't reading...

    I don't have precise pressures. I wasn't reading the computer data. The mechanic whom I have been using for 20 years told me all of that stuff showed perfect. Voltage, fuel pressure (was 111 and it...
  9. Replies
    15
    Views
    2,248

    I have 2 tanks and it does it on both sides....

    I have 2 tanks and it does it on both sides. Also, I have full pressure at the injectors so it isn't a tank or line supply issue.
  10. Replies
    15
    Views
    2,248

    It starts and idles perfectly. The hole shot is...

    It starts and idles perfectly.
    The hole shot is fine.
    It runs perfectly below 5300 rpm.
    Wide open it will only go about 62mph when normally it does 72 mph. It's a ranger 521vx max rpms are usually...
  11. Replies
    15
    Views
    2,248

    Pro xs hesitating

    I have a 2016 Mercury 250 pro xs. When it gets to about 5300 rpm it backs off about 200 rpm. Then it does it all over again every time. I spent 6 hours with my mechanic yesterday and did the...
Results 1 to 11 of 12