Search:

Type: Posts; User: Milo30

Page 1 of 11 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    274

    thanks

    thanks
  2. Replies
    3
    Views
    274

    Windshield hardware

    I have a 94 176 and am missing a couple of the male end twists that secure the windshield to the console. Sorry I don't know the actual name of the part. Does anyone know where those can be...
  3. Thread: Repowered 176

    by Milo30
    Replies
    14
    Views
    871

    I haven't had a chance to get back on the water...

    I haven't had a chance to get back on the water yet. I am considering pulling the extra battery. Yes it trims the same distance and the transom is dry. I had to remove the old transom a few years...
  4. Thread: Repowered 176

    by Milo30
    Replies
    14
    Views
    871

    Had a Mercury 115 before so the 4 stroke 140 is...

    Had a Mercury 115 before so the 4 stroke 140 is about 100 lbs heavier.
  5. Thread: Repowered 176

    by Milo30
    Replies
    14
    Views
    871

    No jackplate. I thought about adding one to see...

    No jackplate. I thought about adding one to see if that would help but the dealer who installed it and Hydro Dynamics did not think that it would solve my problem and recommended that I not add one...
  6. Replies
    14
    Views
    1,138

    I think you are right on the 2 side lockers now...

    I think you are right on the 2 side lockers now that I think about it. The center storage is the one that I have seen water standing in and I removed the carpet and it is sealed on all sides.
  7. Thread: Repowered 176

    by Milo30
    Replies
    14
    Views
    871

    Repowered 176

    I recently repowered my '94, 176DC with a 4 stroke 140. The transom always sat low in the water before and now with the extra weight it sits a little lower. I run 4 batteries in it, could eliminate...
  8. Replies
    14
    Views
    1,138

    It is elevated at the bow and the drain plug is...

    It is elevated at the bow and the drain plug is always open. It isn't getting water in on the lake or due to the plug. It has drain holes at certain areas on the deck but the carpet is so tight...
  9. Replies
    14
    Views
    1,138

    Thanks, good advise

    Thanks, good advise
  10. Replies
    14
    Views
    1,138

    I dont have any latches on these lids. They are...

    I dont have any latches on these lids. They are the pull tab on the sides type. I do elevate it as high as I can. It is usually covered but when taking it out sometimes get caught with cover off. ...
  11. Replies
    14
    Views
    1,138

    Yes it does have a raised lip and seal but water...

    Yes it does have a raised lip and seal but water is still getting inside of all of them. Guess I will maybe try replacing the seal with another type.
  12. Replies
    14
    Views
    1,138

    water in storage

    I have a '94 176dc, I constantly have water in my rod boxes and center storage and recently had to throw away 3/4 of my lures due to rust. I am assuming that the lids are so close and tight to each...
  13. Replies
    7
    Views
    418

    I got the boat back Friday, took it to the lake...

    I got the boat back Friday, took it to the lake to start the break in. That motor is a beast. It is so much more responsive, quieter and is going to be way faster than the tired old 115. Took 30...
  14. Replies
    5
    Views
    358

    That is what I was thinking. It would work but...

    That is what I was thinking. It would work but would not have enough length for rougher water. I was thinking about that same motor but saw it was only 45" also. i passed on the Ultrex and will...
  15. Replies
    5
    Views
    358

    trolling motor shaft length question

    I have a '94, 176. Right now I have an Ulterra 60" I believe, but hit a stump too hard and now it can't deploy. Already put a few hundred into it but still no luck and before I put it in the shop...
  16. Replies
    7
    Views
    418

    Yes Bigsdaddy, it is Fork. I have an RV out...

    Yes Bigsdaddy, it is Fork. I have an RV out there and it has been murder going out there with no boat.
    I got a deal that I could not say no to so my boat is in the shop and they are putting a new...
  17. Replies
    7
    Views
    418

    I am not a speed demon but that would be great. ...

    I am not a speed demon but that would be great. The 115 tops out at around 39 gps and is really slow at getting out of the hole. I had to remove the talon because it just caused too much drag and...
  18. Replies
    7
    Views
    418

    '94 176 repower question

    I have a '94 176DC with a Mercury 115. I was recently out on the lake and when I restarted the motor it started knocking for a few seconds and then stopped and wouldn't start. After getting it back...
  19. Replies
    1
    Views
    168

    1994 176 question

    I have a 94 176DC with a Merc 115. I bought it a few years ago but injured my back and having surgery. It is probably going to be at least 2 years before I will be able to fish again. I don't want...
  20. Replies
    3
    Views
    417

    If it is just the transom that is bad, look into...

    If it is just the transom that is bad, look into a pourable transom. I've done 2 of them and they were very solid transoms when done. Been a couple of years now on my Champion and still going...
  21. Replies
    29
    Views
    2,026

    Between work and the hot days this year, mine has...

    Between work and the hot days this year, mine has hardly been out either. I'm losing my motivation and now I am looking for reasons not to go when I do have the time. I'm almost to the point of...
  22. Replies
    10
    Views
    560

    Thanks for posting that pic. I just found this...

    Thanks for posting that pic. I just found this console about a week ago and was considering it for the price. Don't really use the step much as I mainly fish solo and just wanted something more...
  23. Thread: Xi5 or ultrex

    by Milo30
    Replies
    26
    Views
    875

    My Ulterra is a lot quieter and more responsive. ...

    My Ulterra is a lot quieter and more responsive. It is one time that the next generation of something really addressed many of the 1st generation flaws.

    I figured the others would follow...
  24. Thread: Xi5 or ultrex

    by Milo30
    Replies
    26
    Views
    875

    Well if you have the older terrova you’ll love...

    Well if you have the older terrova you’ll love the improved spotlock if you ever upgrade. I just have the gen 1 di transducer so I got lucky
  25. Replies
    10
    Views
    560

    Bassboatseats.com recently came out with a new...

    Bassboatseats.com recently came out with a new one and it is priced right at $99. I'm planning on getting one to put on my ice chest lid between the seats.
    ...
Results 1 to 25 of 262
Page 1 of 11 1 2 3 4