Looks like it was the stop screw on the hot foot. Thanks again
Type: Posts; User: Hutch20XHP
Looks like it was the stop screw on the hot foot. Thanks again
Hey guys looking for some advice. Had a tournament yesterday and engine would not reach top speed. Almost like the hot foot is not getting it to wot. I did have full wells and 3/4 tank of gas on a...
Running a 26p trophy plus on a 2008 merc 250 pro xs. By myself holeshot is ok, but fill live wells and tourney load she is sluggish. Recently added two 12' talons, love them by the way, so I did add...
was driving up the river and heard popping sound. had to troll back to launch and found two small cracks on each side of lower unit, one is leaking lower unit oil. motor won't go into gear. ...
need to replace trim motor on an 2008 250 pro xs, serial number 1b553488. Never done one before, just looking for any info. hoping its easy to take off and install, or should I bring it somewhere. ...
sorry to hijack your post but my 08 250 pro xs did the same thing last week. every time the trim stops working, it just comes back a few minutes later. can hear the same clicking from the relays...
Don, I checked all the coils with a timing light and found one that was not working. That will make four coils now. I'll be calling the local shops tomorrow to see if they have any in stock. ...
took the boat out today for the first time for the season. engine started right up, but after allowing it to warm up, it would not plane out easily. after fishing a bit, started engine and she...
hey don, I trimmed the engine down to see if any more oil was leaking out(with the drain plug in). After letting it "drain" for a couple of hours, I checked the pan underneath it and there was...
just got the boat out and noticed that when engine is trimmed down, I have lower unit oil leaking from the bottom screw (the one under the prop). Could I have tweaked the little plastic seal thats...
thanks for the reply, looks like I'm going to invest in one.
recently upgraded electronics and looking to upgrade crankin battery as well. lookin at the sears die hard platinum 31. wondering if anyone has one and if they have good luck with it. meets the...
I changed the lower unit lube, and I was only able to put in about half a bottle before it came out of the top screw. Is this right? I seem to remember my old 150 mariner taking almost the whole...
is the drain plug behind the prop?
Hope someone can help me out. I lost the round center cap that fits over the lug nuts and on the wheel. It looks like the screw just fell out. Does anyone know where I can get one of these? ...
after a week of waiting at the shop, finally heard back about my motor. bad coil on cylinder #4. Getting her back on Friday, hope everything runs fine. Quick question, do I need 6 new plugs or...
Will do, thanks Don.
fishing a tournament this past weekend, and after partner drops me in the water I start the engine and all seems normal. engine started right up. time for my boat to blast off, and I give her...
thanks Don, are these in stock or something that has to be ordered? Thanks again.
looking to install one of these, just wondering where the best place is to get one from, what exactly I need, and how much I'll spend, thanks.