Search:

Type: Posts; User: Northwoodswalleye

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Yep same thing on mine

    Yep same thing on mine
  2. Replies
    8
    Views
    1,024

    how much positive trim? My boat lift is very...

    how much positive trim? My boat lift is very shallow so my motor usually sits at 75-90 degrees. 250 hours no smoke on startup or plug fouling so it must be ok?
  3. Replies
    41
    Views
    3,065

    I’ve had one for 2 years and have 200 hours on...

    I’ve had one for 2 years and have 200 hours on it. Replaced an alternator and a couple of bulletins but I’d buy another without even thinking about it. They’re the real deal
  4. Replies
    24
    Views
    1,220

    Smb are hated by most up north! Invasive...

    Smb are hated by most up north! Invasive species-take some home with you lol
  5. Replies
    1
    Views
    286

    Had same issue with mine. I made up a wire...

    Had same issue with mine. I made up a wire harness with a 40k ohm resistor in-line with the trim sensor output wire and got all the trim I was missing
  6. Replies
    8
    Views
    2,934

    I finally got time to retrieve my boat tonight...

    I finally got time to retrieve my boat tonight and found a blown pcm fuse. Alternator gets replaced tomorrow and should be back to normal.
    Update
    New alternator did fix all the issues
  7. Replies
    11
    Views
    3,090

    I have the gateway hooked to a garmin and it’s...

    I have the gateway hooked to a garmin and it’s awesome all the data you can get live on screen
  8. Replies
    8
    Views
    2,934

    I did see 16 volts on the smart craft today

    I did see 16 volts on the smart craft today
  9. Replies
    8
    Views
    2,934

    Alternator failed today. 4602-23 fault code. Made...

    Alternator failed today. 4602-23 fault code. Made it back with the kicker motor.
  10. Replies
    8
    Views
    2,934

    I am am waiting for an alternator for my 200v8...

    I am am waiting for an alternator for my 200v8 proxs. Mine started undercharging last week. Showing 11.3volts on the smartcraft during a long run down the lake. I’ve used it a few times since then...
  11. Yes it will display fuel used. If you wire the...

    Yes it will display fuel used. If you wire the gps to the Smartcraft it will give you miles per gallon. I picked up a nmea2k gateway and plugged that into my garmin and get more data than the...
  12. Replies
    13
    Views
    1,338

    My 200 v8 doesn’t make oil. It gets run hard tho...

    My 200 v8 doesn’t make oil. It gets run hard tho and very little trolling with it
  13. Looks like 3 beeps can mean low voltage. I was...

    Looks like 3 beeps can mean low voltage. I was out with my boat which has the same motor as you over the weekend and noticed my voltage all over the place. After a 20 minute run I had 11.2 volts. The...
  14. Replies
    8
    Views
    643

    I like to set it up at the top of the rpm range...

    I like to set it up at the top of the rpm range (6200) when the boat has 1/4 tank of gas and just the driver.
  15. Replies
    15
    Views
    3,452

    If the block and everything in the block are the...

    If the block and everything in the block are the same part numbers i wonder if mercury may have 2 longblock part numbers for the same pieces to be able to charge more for the bigger motor.
  16. Replies
    15
    Views
    3,452

    I did go and check the part numbers for the...

    I did go and check the part numbers for the block, crank, rods, pistons, etc for 200-250-300 pro xs and found them to be all the same. This was on Mercury’s website. What am I missing?
  17. Replies
    15
    Views
    3,452

    200 v8 can get flashed to 245. Change the...

    200 v8 can get flashed to 245. Change the throttle body and it can go to 325hp. The 250 or 300 can go to 325
  18. Replies
    13
    Views
    1,177

    Bravo 1 LT 19p

    Bravo 1 LT 19p
  19. Replies
    4
    Views
    681

    8M0142656 8M0142655 these are the part...

    8M0142656
    8M0142655

    these are the part numbers for 225pro xs pcm from mercury’s Website
  20. Replies
    44
    Views
    8,021

    Part the old motor out on eBay.

    Part the old motor out on eBay.
  21. Replies
    15
    Views
    1,065

    Check the prop for damage?

    Check the prop for damage?
  22. Replies
    11
    Views
    666

    Local dealer had issues with one and it turned...

    Local dealer had issues with one and it turned out one of the wires in the plug for the alternator wasn’t pushed all the way in. Something to look at
  23. Replies
    9
    Views
    2,098

    Too much pitch and probably the motor is too low....

    Too much pitch and probably the motor is too low. The gear ratio may be different from the old motor. I’d try a 20p on it
  24. Exact inch of pitch is approximately 200rpm. A...

    Exact inch of pitch is approximately 200rpm. A 4-blade usually needs to be run higher. Each 3/4” is 100-150rpm. In my opinion you need to go to a 17 or 18 pitch 4-blade to get the rpms back where...
  25. The 200 v8 pro xs that I have has the 1.25” shaft

    The 200 v8 pro xs that I have has the 1.25” shaft
Results 1 to 25 of 67
Page 1 of 3 1 2 3