Search:

What should the tps read on a volt meter. I'm going check the fuel lines tomorrow. Yes the belt is still in tact.

I have 1999 225 mercury optimax. When I try to get in the throttle to get on plane it starts spurting and shaking. Then the boat will die. When I start it back up it idles smooth until I get back in...

I have 1999 225 mercury optimax. Inside the prop there is a lot of sticky black soot in the prop what cause this.

I don't know for sure. I will have to call him and see. He just told me everything was fine and was not sure why I was having such a hard problem getting out of the hole. I never had this problem...

Its a 1999 225 Mercury Optimax. I serial number is 0G945670. I have been having problems getting out of the hole. When I get n the throttle to get out of the hole it sounds like it is starving for...

I read a post on here a while back on loss of power from engine because if his cranking battery. How could this be so. Seems to me if the battery will start your engine then your good to go. I don't...

I have dual tanks on my boat my fuel selector went out. What would happen if was to tie both tanks together. Would there be any repercussion on the engine performance just curios. Thanks for any...

Is there anyway to adjust the trim. I have a 1999 225 optimax my holeshot stinks. Tried abosultely everything possible. My buddy has the exact same boat and motor and is motor when trimmed down. Is...

I been having problems getting out of the hole with my boat. I have a 225 mercury optimax dfi. I took the plugs out today to look at them to see if they looked fouled. They have white residue look on...

I like to be able to make some jigs with the wire brush guards. I am having a problem finding the wire. Does anybody know where I could purchase. I already make jigs with the fiber guards,but really...

Don,

I tried to look up injectors on the website. I couldn't get it to pull my motor up it is a 225 mercury optimax dfi. My questions are what does it cost to service and replace with new ones....

My motor is sitting at 3" below pad right know. I am going to raise it up to 2" and give it a try this Friday. I will get back on here and let you all know how it goes. I'm going try that and ease it...

WOT is 5800rpm that is the max on my motor. When I mash the gas the motor will jump to about 3500 and gradually increase as it gets out of the hole. I use to run 26p tempest and it would do the same...

I have a 210prov with a 225 merc optimax. My pads is set at 3in. I am running a 26p fury prop. My hole shot sucks. My top end is around 71gps. Nothing like some of guys on the board are running. I...

I have 1999 225 Mercury optimax . I took my cowling off to check some things out and noticed that my air handler cover was gone. I don't know how or when this has been missing. I'm going to get it...

Well i Finally got to take my boat out. I raised the motor up 1/4 inch just to see if it helped. It seemed to be a little better but might have to go more. I think I need a new water pressure gauge...

I am running 5600 rpm at WOT and top speed is 71mph and water pressure is 25 that me by myself. With 2 people same rpm and top end speed is 68mph same water pressure. I do have a 10inch jack plate on...

My serial no. is 0g945670. I do get more then 4500 rpm when it finally gets on plane. When I get on plane it has no problem getting to max rpm. The problem I have is it seems like I don't have enough...

My boat has been to 2 seperate mechanics and they can't figure it out just kept putting new stuff on and didn't fix. I have 2 Question to start to see if i can check some things. What is the proper...

I have a serious problem getting out of the hole with 2 people in my boat. When it is just me by myself it jumps out of the hole. I'm turning close 4500 rpm when by myself when there is 2 of us it...

I had to replace my steering hoses on my boat. I pinched one of the hoses when i took the battery out. How do you bleed you steering.

There is no plugs in the prop.

My boat is blazer 210 pro-v. I have had this boat for about 4 years. I had a the mechanic look at this several times for this problem, but he has never seemed to figure it out why it does it. We have...

I have 1999 225 mercury optimax. The hole shot is incredible with one person, but just as soon as a another person gets in the boat it takes forever to get on plane. The motor sounds like it doesn't...

My engine was rebuilt 3 years ago and they put carbon fibers in. Should i put them back in or should go back to steel.