353415353416
I used existing screws on bottom and slid top under. I was too scared of the tank to put new screws in.
Type: Posts; User: Phishinguy
353415353416
I used existing screws on bottom and slid top under. I was too scared of the tank to put new screws in.
I ended up bending 2 flat pieces of aluminum and tucking them behind the warning plates. A bit of messing around but it was cheap and works fine.
I would look into a bravo1
Recently purchased new boat. 04 Tr20 with a 225 pro xs. I put a 4 blade 25p trophy plus on. Prop was blowing out badly on hole shot. I put in all 4 solid PVS plugs. Hole shot improved however...
Just bought some on Amazon. Ordered twice, stock 40lbs wasn't enough. Went with 80lb supports, work great now.
Not sure on those but i know Little Butte Des Morts is open. Its always first.
Did she Find you the foam trim piece? I emailed her earlier in the week about it and haven't heard back. If you are looking for just the wood grain plastic panel I will give you mine.
Our Club always fishes Sturgeon Bay opening weekend. Weather has finally cooperated this year. Should be a blast.
This is even a crap shoot. Neither of these places are up to par. Save yourself the headache and order from tackle warehouse before you make the trip.
Can't believe it took that long. :roll:
:crying:
looks like you just need a new hub
I took my maxxum apart to replace the bearings hoping it would fix my noise issue and found the top of the shaft to be severely damaged. There is a large grove and its all cracked up where the...
I had this problem last year. Was just bad connection on my fuse holder. Replaced fuse holder and put new rings on. May want to check crimp connections.
Stiletto huh? Where did you find them?
Didnt know they were coming?
I just took my pot apart and ran hot water in it. All that brown crusty stuff comes out easily with water and a little elbow grease.
Anytime I have this problem smoking the mold makes all the difference. I just hold it over the tip of a candle until the cavity is nice and black.
We are a small club out of Green Bay with about ten guys. The club is affiliated with FLW (Wisconsin Bass Federation) www.wisconsinbass.com Yearly dues are $100 which makes you a member of FLW. We...
Not a difficult task... Lots of info on here and youtube. I think you will need an aftermarket one. Ranger didn't have the hidden tray until 05 or 06.
Kieth Combs guides on falcon. Couldn't find a nicer guy and I think his resume speaks for itself.
had this problem, ran new ground from sending unit to gauge. Good luck
Packerland Bass open on high falls flowage. July 14th 'boat landing three. Entry form available at packerlandbassclub.com
where did u get the plug?
fox is open in DePere