Pm sent
Type: Posts; User: Steve O.
Pm sent
Yeah, take the little strainer on the end of the tube off and do a trial run on a piece of cardboard. Do the thinning like you did before. I have used it to fix a lot of small nicks in my gel. ...
Did you take the strainer off of the bottom of the pick up tube?
Pm sent
I'll take them. Paypal?
I will take a closer look. There was melted plastic fragments on the plug boot. But will take a closer look. Thanks
Thanks for the help on the post. I just wanted to make sure the coil pack wasn't going out or other issue. I made sure the plug wire is tight and dielectric greased. The bracket right below this...
I was winterizing my 2016 200 Pro XS, serial 2B125002 today and found the wire jacket melted. It is at the back top of the engine above one and two cylinders. Tell me your thoughts.
Thanks
Nope
Very sorry for your loss.:praying: :praying:
:praying::praying::praying:
Totally agree!!
:praying:
This is a new to me 360 that purchased used. Is this interference coming from my ultrex? Sensitivity is at one but nothing seems to work to make the image clear. It was connect to a 998HD and also...
It's awesome!!! Lets me focus more on fishing. Especially when I have the kids ages 5 and 10 fishing with me.
Thank you for the reply's everyone. What I am hung up on is on the Ultrex, the manual says the Ultrex should be disconnected or isolated from the charging source. What I am gathering is that...
That is why I have been thinking of getting one, because of the rivers I fish. Do you have to unplug the trolling motor or turn it off? I am running an Ultrex.
Been kind of leaning toward getting one for a while now. Just not sure if really need it. Just looking for some opinions of pros and cons. Thanks
I did check the fuse in the head of the ultrex, it checked good. The trolling motor is brand new this year. I didn't mention it in the first post but the interference is at constant running speed.
I have an Ultrex and 998 transducer mounted on the foot of the trolling motor. I am getting horrible interference on side scan.
This is what I have done already.
Main power cord in the newest...
Need to unbolt the tank because of a leaking aerator replacement job. Seems straight forward, there are 2 brackets loosen the 2 screws going into the boat and slide back? I did drain the fuel out...
Thank you
Has anyone had any issue with finding a replacement fuel sender gasket that goes on top of the tank? Just looked at the Bass Cat store and did not find it. Was going to try to call Bass Cat...
I have purchased new and used boats from them. Honest on price and how long service will take. I wouldn't hesitate buying from them.
That is what I was hoping that's all I needed to do was keep it trimmed level to self drain.
Thank you