I think I have a bad install. My friend, who knows everything about these units, told me he couldn’t get the picture any better and suggested I never use it. My option is to buy another thru hull...
Type: Posts; User: Case3015
I think I have a bad install. My friend, who knows everything about these units, told me he couldn’t get the picture any better and suggested I never use it. My option is to buy another thru hull...
I have a Lowrance 3D transducer and a thru hull transducer. The thru hull transducer’s 2d sonar is terrible. I never use it b/c the imagine is so bad. For those of you who who have the 3D transducer...
My max speed alone is about 62 and when I fish with someone it is 56. I am running a yahama 25-T1 prop on my 200 yahama Sho. 7 dots is are showing on my slidemaster jack plate.
Question..is my...
Thanks, I will try to fill it to the top next time. I will have to do the turning the gas pump 180 degrees trick next time because it is clicking off.
My ZX200 has two 25 gallon tanks.
Here is a picture of the gas line when it clicked off at the pump. About 2 inches from the top. This is 17 gallons. Do I need to try to fill the entire gas tank...
I have a 2014 ZX200. It has dual 25 gallon gas tanks which can not be ran dual only single. My last time out fishing the portside tank was ran until empty, motor died. I switched to the starboard...
Thanks, rolling back to 7.0 today on both units. I just want the sonar to work so I can concentrate on fishing.
Both of my Lowrance HDS Gen 3’s started doing this pauses and freezing every second or so. Down imagine was also doing this. Both units worked great my first 3 hours of fishing then this started...
Let me know which bilge pump you pick for your second pump and take a picture of where you drill the new hole at.
I have a ZX200 2014 and it only has one 800 gph automatic bilge pump. I was thinking about adding a second pump mainly because it is already wired for a second one. There are three connection wires...
Where can I find an 1 amp fuse holder? Do you have a link to one. I was searching for a water proof one and I can not find one.
So I installed my heading sensor in the very back of the boat. It would be really easy to just hook it up directly to the battery. Do I need to install an in-line fuse first? If so what size? The...
I have the 45” on my ZX200. It has been a perfect balance. It is a little longer (a little over 3 inches) than my old 45” Fortrex that I took off.
Thanks
Are yall running it along the base or connected to the Ultrex cable? Any interference on your graph if it is attached to the trolling motor cable?
I have a total scan transducer for the Ultrex...
Own
Does the heading sensor connect automatically when you start using the Ultrex?
I’m about to install the Ultrex puck to the stern of my boat. Should I connect it directly to the battery or run it to the power switch on the helm? For those who hook it directly to the battery...
It will if you get the same length.
This is a good question. I was going to just directly hook mind up to the battery but if you do this will it drain your battery 24 hrs a day?
I have a Yahama 200 Sho. One of my gas tanks is almost empty. After I empty it I'm going to put 5 gallons of midgrade in it and see if I can notice a difference.
I have been using unleaded octane 87. I use Yamaha Ring Free and Yamaha Stabilizer in every tank. Guy at the Skeeter dealership told me to try Premium gas and I should see an increase in my speed....
I wish there was a way to book mark these threads.
Sounds good.
Thanks for the post