I don’t think there are fuses on this year ranger. I could be wrong. I’ve tried everything that I know to check
Type: Posts; User: mikerich
I don’t think there are fuses on this year ranger. I could be wrong. I’ve tried everything that I know to check
2015 z520c the live well on the port side pump doesn’t work. I have no power going to that pump. I can switch the connectors from the port side to the starboard side and the port side will work. So I...
Just purchased a gen 4 helix 12 SI. Did the update to 2.8 on the unit. The chart is still really slow and takes 15-20 seconds to load charts while running around the lake. What could be the issue?...
Yes I found the link from a buddy and order those. Thanks again
It wobbles bad half deployed so I have some ordered. I have a set of plastic ones and a set coming that are cnc machined to fit. Thanks for the help.
Ok will check that. Thanks
Might be dumb question, how would I know a pivot bushing is blown out?
This weekend I noticed my ultrex is very hard to pull up, it’s almost like the trolling motor head has to be pointed in one direction for it to release to come out of the water. Anyone else have...
Is a 12 gen2 SI, I see they have multiple on the website for it. It will not take the update and I can’t figure out why
My helix 12 gen2 will not take the update? And is really slow when using chart mode?
The part in the carpet is bigger than the other 3 in the boat and worn out is what your saying?
2015 520c pedestal plugs. I ordered 4 of the 1.77” 3
of them fit in the boat using a little electrical tape on them to plug the holes. Now the one close to the trolling motor is bigger in diameter...
Thanks
Can a gen 2 and gen 4 link together? Share way points information. Thanks
The water is running out the overflow I believe, when water is rough or getting in plane. I think the valve is working properly, it’s 2 holes at the top of the livewell.
2017 zx225,
looking for the live well drain plugs. I have one plug but two separate drains in the livewell and loose water
when running around the lake. Thanks
Power pole said I had a bent bracket adapter. Thanks for the replies
They look the same height? And what about in jackplate? Or the brackets the same in jackplate?
Power poles are mounted the exact same spot on the jackplate, but one is taller than the other. Anyone ever experienced this? Trying to upload a picture.
Now it’s the exact opposite. I took the panel off to see if anything was wrapped around shifter. Pulled a rope through the area for new transducer wondering if I wrapped the rope around shifter...
225hp sho is really easy to shift into forward, but is very stiff going in reverse, is that normal?
So with 7 dots showing that’s factory, and mine is showing 4. So it would need to be raised? But then I definitely loose any lift. And wot is 5700rpm. And it’s shooting a rooster tail higher than...
It has the Yamaha prop that came with the boat. T1? I believe the jackplate is low. But not lifting it should go down. I’ll see if I can lower it and get 70 out of it.
2017 zx225 SHO 225hp, boat doesn’t have lift? Getting 61-63mph. 4 dots showing on manual jackplate. Boat has poles as well. Just seeing what everyone else with this boat jackplate and speed is. Thanks
Sounds good guys. Will try it tomorrow