You ARE the man………….man!
Type: Posts; User: vvrick
You ARE the man………….man!
Is it possible to replace a bad trim motor without taking off the whole tilt and trim unit?
I have a 2003 Evinrude E200FPLSTM mounted in a 2003 Champion 196 and I am trying to identify what remote control was used. More specifically, I’m trying to order another neutral safety switch...
If you don’t mind, can I ask what you paid?
Who has replaced the carpet in the cockpit with a vinyl/rubber alternative? If so, brand, cost and did you order pre-cut and install yourself? Thanks
Got my Raker back from Steve’s the other day, can’t wait to take it out. I think the guy that worked it was Josh.
Yes, I do have a service manual and a fluke multimeter….
Pretty sure the neutral safety switch is ok, wiring looks good so I think I will start with the cheaper stuff first such as; starter solenoid and all the relays and go from there. Thanks for the...
E200FPLSTM with approximately 300 hrs. I replaced the ignition switch hoping that would solve the problem, to no avail. Always starts when cold then sometimes when ready to move to new spot, it will...
Hi Pat! Well I finally found my original Raker (14.4 X 24) and man, it looks brand new. My question is; I know you had suggested Croxton to B&B, but do you know anything about Steve’s over by Lake...
Does anyone have an original 14.5 x 24p Raker they are willing to part with. Crappy condition ok.
Hey guys, looking to change from OMC 4 blade (Cyclone) to 3 blade. My boat and motor: 2003 Champion 196 w/2003 Evinrude Ficht 200 hp. I top out (5700 rpm) at about 56 mph. Others have suggested an...
I was told I really need a 24 Raker, preferably worked but have found them to be pretty scarce.
I was told I really need a 24 Raker, preferably worked but have found them to be pretty scarce.
When you say it is not working because of set-up. Reason for asking, my boat is an 03 Champion 196 with a 200hp Evinrude Ficht, 10” jack plate. Currently running an OMC Cyclone.
Probably used.
Has anyone ran Evinrude originally and re-powered with another brand O/B? If so, which brand is less work/cost to rig and replace the Rude.
Reggie, I forgot to tell you but we spent a couple of nights close to Abilene in a neat little place called Buffalo Gap. We were on our way to Big Bend for our 40th wedding anniversary. We stayed at...
Does anyone have a wiring diagram for a 2003 196DC Champ?
Without a doubt…..
Thanks Rick
DELETE please………Looking for good used clean Solix……..anyone?
When trimming down only my motor bounces fairly violently. Have made sure the seal nuts are all tight and unit is full of oil, but it continues to bounce. The motor (200 hp), and tilt/trim are...
My 03 196 has Lebroc seats
Currently have a 24 Cyclone, bout 60 mph, but great holeshot.