The carpet was factory installed, 2019 920 proxs.
Type: Posts; User: Grak767
The carpet was factory installed, 2019 920 proxs.
491284
looks like carpet glue that was applied to heavily and when heated by the sun
has soaked into the carpet, I have these two spots and one other, anyone have
a way to remove the stain? ...
Does anyone know what the white caulk is that Phoenix uses on the trolling motor bus bar at the bow to cover and protect the power wires from a short? I had to scrape it off to have the trolling...
I tracked all the wires back to the fuse block and tested by pulling the fuse and seeing if the unit turned off. Will just pulling the fuse to those wires be sufficient? It will will leave power at...
386535386536
trying to install new wiring to all my electronics to a dedicated fuse block, and then straight to house battery, thought a dedicated battery power switch. What do I do with the...
Argued with my prop guy between a 24p and 25p. He was concerned that after adding a lot of cup to the 25 the rpms will drop to much. He said it was easier to add cup and pitch to the 24 to dial in...
I ran the 26p Tempest+ today, could not really turn it.
time to plane: 3.8 sec
WOT rpm: 5750
top speed: 76.4
found a good deal on a 24p Tempest+ that I’m going to have worked for more bow...
I got my hands on a Tempest+ 26p to try today, I’ll post results later, thanks.
Come on guys, need some feed back.
do most guys need max trim for best top speed in a 920? I’m coming out of a Bullet 20XD where just over half trim was the sweet spot so I am trying to figure...
2019 920 ProXP 250 Merc ProXS 4s.
My thoughts, the 26p fury seems jacked up, it’s numbers are way off from the 24p and 25p. I bought the 26p used and have no info on it. With the lithium...
I got it figured out, my live well drain fitting was cracked on the back side. It’s a 1 1/4” fitting.
Thanks for the replies, I found the problem, the left live well drain. The 90 degree elbow on the back side was cracked and almost completely broken off. Dealer is sending me a new one.
Does anyone know the socket size needed to remove the livewell fill fitting on the backside of the livewell that the hose attaches to, mind is cracked and leaking.
also what sealant should I use...
Thanks for the replies.
I’ve got a 6 month old 2019 920 ProXP, the boat has sat cover on and on my boat lift in a covered dock for the last 3 weeks without running it.
I took it out yesterday, and after fishing a spot...
I got it figured out, the 3 way switch was wired wrong putting the crank and house battery in parallel instead of isolating the house battery.
367669367670
The console is helix 10s with the gimbal mounts directly installed on the lower gauge dash shroud with aluminum backer bars (factory installed.) FYI 12 inch units at the console will...
I wanted to keep the weight of the box aft, so I ordered the transducer extension cable and the 6 meter network cable and mounted the GLS10 in the rear compartment near the cranking battery. I run...
I found the trouble, had to remove the 3 way battery switch, at install they put the boat battery bus on the cranking battery post on the back of the switch instead of putting it on the house battery.
It is odd, the motor will start with the 3 way switch in off as it should and the master power is all dead and no electronics work. Put the 3 way switch on the house battery and the master power and...
Running a 2019 920proXP. Have the electrical system setup with TM batteries isolated, then a crank battery and a house battery with a 3way switch to either isolate or combine the crank and house...
Running a 2019 920proXP. Have the electrical system setup with TM batteries isolated, then a crank battery and a house battery with a 3way switch to either isolate or combine the crank and house...
I was having this issue, both before last software update and post update, it got progressively worse even after trying every suggestion on this board. My GLS10 box would slow flash 3 reds in a...
I like my gain turned up on the high side, 70 to 75 in 20+ feet of water, 65 to 70 in less, it does produce some clutter. However, the clutter is stationary and the fish returns move and are...
I’m sure the technology will get better over time, but being able to see a for sure fish(even if it looks like a vertical dash) 70 feet in front of the boat and see it react to your bait is awesome. ...