Check float real good.
Richard aka Kllr Bee
Type: Posts; User: kllr bee
Check float real good.
Richard aka Kllr Bee
I have a beede gauge that froze and worked but only went down to 15 pounds. I took it off and took the light bulb out and there was a brass ring I could see inside. I got a small screwdriver and put...
Take the gauge out of boat. Take light bulb out and you will see a copper ring inside put pressure on ring with small screwdriver and see which way needle moves, then bend til sets back to zero....
I have an older Ulterra that will start deploying and as it starts to tip down it will stop and start beeping. It will not continue but will retract. If you help it start moving by pushing a little...
Put a straightedge on your jackplate engine mounting surface extending down below boat. Measure distance from straight edge to bottom pad on boat. Mercury Racing recommends 1 inch of setback per...
Liquid sex!!!
Richard aka Kllr Bee
My 2006 21XD COMP had a tour 82. I fish mainly single and got a minn kota Ulterra. You could not get me to give this baby back even if it cost me mph. I can launch alone and fish from anywhere in...
I had a 2010 300XS. Ran it 13 years with nothing but Premium Plus per Mercury specs. Never turned a wrench on powerhead. Also most people on here know I will not hesitate to push one to the...
Always use Mercury parts on a high performance motor like this one. Some parts on this motor are not just 3 liter parts. Pay a little more now for piece of mind and fewer failures.
Richard aka...
Boyesen 2 stage reeds........ I will put them against any reeds made. Better low rpm performance, mid range performance, and topend performance. Remember me?
Richard aka Kllr Bee
My brother-in-law and all the other million plus soles that died from covid would not call it political flu. Not funny!!!!!
Richard aka Kllr Bee
If it will exceed 80 it needs a sport master. I bet it would if set up right. On the sport master vs coned torquemaster, I ran 1.5 mph faster with Bob's coned torquemaster over factory sportmaster....
Howbout we put it this way, would a motor run better at sea-level or in say a mountain lake at 10,000 feet elevation?
Richard aka Kllr Bee
Angleiron, If you're straw was pulling air through a smaller straw it would be the volume that the smaller straw would handle. If a motor runs better with more air it means it is designed to...
#1 black spray paint matches perfectly with Mercury color.
Richard aka Kllr Bee
I did see an article done by a guy with a naturally aspirated 300R that said his motor picked up 5 to 6 mph. I know that when I was modifying EFI motors that raising the back of the cowl and adding...
Google Venom Vents and watch the video.
Richard aka Kllr Bee
Sucks that Mercury would sell a 300 Race motor and starve it by limiting air delivery to the motor. Taking all the fun out of fast bassin.
Richard aka Kllr Bee
The computer is designed to take the air intake and match with fuel output and be efficient. More air and more fuel makes more fun efficiently. Look the product up and watch the video. Those intakes...
Do you work for the EPA? I think increasing air flow would help a motor run leaner and more fuel efficient than the stock configuration. Put that in your pipe and smoke it.
Richard aka Kllr Bee
Just watched video about Venom Vents and they make a big time difference on excelleration and top speed on a 450R that was tested on. Would adding Venom Vents void a Mercury warranty seeing that all...
JAZll,they could be performance addition if.......
Richard aka Kllr Bee
You know me. I'm always chasing extra juice!!
Richard aka Kllr Bee
How much does a sat cost? I have an idea.
Richard aka Kllr Bee
Best setback rule is 1 inch per foot of boat. Straight edge on back of jackplate to bottom of hull.
Richard aka Kllr Bee