That is how I tested it. I can blow thru it
Type: Posts; User: Yellow0121
That is how I tested it. I can blow thru it
It flows freely thru the VST. When I pull the hose where it goes back into bottom of the block, there is water coming out there. I think it is enough pressure that it cant pump against it. If that...
Model - E225DHLSUA
The EMM cooking line will not start flowing unless I open it to atmosphere. It is clear all the way down to where it goes back in to the bottom of the block. It is like it is...
I was curious if the engine model number on the EMM and the actual engine model being different would cause some issues. See Pictures421157421158
421095
421094
Looks like it will be here Monday
There is not any leaks or corrosion. It looks brand new. I took the boot off and inspected it
I looked the capacitor over and can’t see any problems. How do I check it? Should I just order a new one
I ordered a diagnostic setup so I can figure out if it has any codes. I will check what you mentioned when I can get to the boat tomorrow evening.
Ok and FYI. It still cranks over but never busts off
My motor is giving me issues and I am looking for some advice.
2007 Evinrude Etec 225
Model Number: E225DHLSUA
The last few times to the lake I had the same issue. I would drive the boat for...
Anyone happen to have one laying around?
It went out of warranty on 3/2018
I bought it on a used boat. I was under the impression when I called Motorguide that it is out of warranty
That is pretty much what I do when it does this.
I bought this trolling motor on a used boat and have not been able to get the Anchor Mode to work. I have the GPS light on and when I hit the anchor button it makes an error tone.
I have tried to...
Mine is doing something similar. Sometimes when I deploy it only the power light comes on and I can turn the main trolling motor switch off then on and it will start working.
Any ideas?
It it...
My prop fell off yesterday and I am looking for another. Could anyone give me some advice on which ones would be the best?
My boat is a 1998 Blazer 202 with a 2004 Yamaha HPDI 250 (originally had...
I have talked to the guy on the phone and he is right down the road. I am just seeing if I can find a powerhead for cheap. If not, I will get a newer one.
Does anyone know where I could find one relatively cheap? I have got a hole in mine.
I have a hole in the passenger side of the powerhead on my 1995 Johnson Venom 200 outboard. I have found another motor exactly like mine with a bad cylinder. Could I split the case and use the good...
I used to live on Fork. Now I live up in the panhandle. Probably the best 4000 I have spent on a boat
I just joined the club. I just picked up a 1995 Viper 201 with a 1979 Johnson 175. It came with the original 200 hp Johnson Venom but it is blown. I plan to repower with possibly a 250.
...
I am in Miami tx now. Is there any way to test the control board?