First time they said oh we’ve seen it once or twice. Now there like what’s going on. I’m going to suggest that skeeter get involved. Because this is crazy. The bearing is like 10 years no...
Type: Posts; User: wthunter11
First time they said oh we’ve seen it once or twice. Now there like what’s going on. I’m going to suggest that skeeter get involved. Because this is crazy. The bearing is like 10 years no...
None at all
No heat. Just a made a 20 hour trip in the boat. Every stop for fuel we checked them no heat. I will carry a temp gun next trip and get an exact temp on them.
All lights work and no brake controller. I don’t hear anything out of the ordinary.
None. It’s starting to get old. Basically it’s five fish one derby take back to shop to fix bearing and repeat.
Yes they replaced back set twice. Now front ones are starting. No real answer as to why. I’m towing with a 2013 Chevy Silverado not that I think that matters.
Yes they are.
Have a 2019 zx250. Had both rear hubs replaced already from leadings. Now my front ones are starting to sling grease. Anyone else had this happen. Or maybe something that could be causing it
I have a 2019 zx250. My back hubs started slinging grease. They are vaults and I know they normally have good reviews. Dealer stated they had two other boat do it. So took it in they replaced back...
thanks guys for all the feedback.
Anyone have picture of how you laid your boat out? leaning on moving rods to port side storage and all my tackle in the center. like to see other setups to get some ideas.
Does anyone have any images from your SI of a brush piles ( xmas trees since thats whats put in around here) that you found then go back over to see with you DI. Trying to get better with locating...
Looking for some better info on marking waypoints with my back machine then trying to line up on them with my front machine ( ledges,brushpiles). Trying to get where I don't have to use a marker...
Yes that’s the piece. Does it move with your prop as it turns.
The plastic bushing that goes between the housing and prop on my ultrex is rubbing making a loud noise. Anyone run into this issue. On the parts list you buy it all together. I took a buddies off his...
One of my helix 12 gimbles bolts came out of my unit. Having a hard time finding just the bolts without having to buy the whole mount. Anyone have a good site to get them from?
Thank you sir
I have a brand new skeeter with a helix 12 linked to a helix 9. I can’t put my cast rings on due to under my nav tab only have 4 options. I notice on the videos there are closer to 10 options...
Thanks guys. It’s a 2019 model so it may just be getting set into place. I was pretty sure the rope didn’t do it but you can understand the concern with a new boat wanting to prevent any avoidable...
Ran over a piece of rope at the ramp today. Motor bogged down and stalled. Cranked back up and loaded onto the trailer. That’s is when I noticed I ran over the rope. It didn’t seem to pull any...
Awesome i pick my zx250 Monday and I cant wait. Did yours come with a smart gauge on it for motor hours and etc?
Ok i pick it up monday and will check then. just curious if it didnt come what the options were. I think the dealer adds the ultrex as a upgrade.
thanks for the info.
Im sure the has been brought up before. I just purchased a new skeeter zx250 that comes with a Helix 12 mega in the dash and a helix 9 on the bow. What all would i need to network them together. Also...
My xp7 has the drain plug in the bottom and the overflow drain next to the spray nozzle. My first question is the over flow drain flows below the water line. After filling the live well the other day...