Update the prop is a 24p not a 23p
Type: Posts; User: MrNoseItAall
Update the prop is a 24p not a 23p
Honestly RPM seems to fluctuate a bit... typically around 5000-5500 at WOT. Tach will run up to 6000 occasionally but I always assumed the fluctuation was because of some interference as the tone of...
I've got a 1996 ProCraft 185 Pro with a Mercury XR4 150 with I believe a 23p prop that is struggling to get on plane at tournament weight (Rods, Tackle, Full fuel tanks, and Full livewells). Looking...
Thanks for the input. That is what I did originally. But it seems that one box was bad when it got to me. So I replaced it with one that I took off. I will probably order a couple more just to keep...
Final update:
Ended up not replacing the trigger after messing with it and swapping around parts once again. Found that the box connected to the opposite side of the dead cylinder was causing the...
I’m going to replace the trigger and see what happens I’ll update when I get it done.
Yes new CDI boxes. If you don't mind, could you elaborate on how the trigger works/is wired and how the switch boxes work. I have looked for this information but all I can find is an overall wiring...
I can only assume so. I have not disconnected any of the wires on the coils themselves except for cylinders 1 & 3 only to see if the issue would move then I put them back. and i did double check the...
alright so I got home from work and switched the switch boxes around. Now I have spark on cylinder 3 and no spark on cylinder 2……
TL,DR: I have a 1991 mercury black max xr4 150 with a little bit of work done, although I'm not 100% sure how much work, that I cannot get spark to cylinder 3, but its not a simple problem. I know...
Recently purchased my grandfathers 1996 procraft 185 pro. It has been garage kept its whole life but still needs a few things. I have replaced all of the pumps and the flow-rite valves and trying to...
I recently bought my grandfathers 185 PRO from him and it needs some things. It has been garage kept its whole life so as far as everything goes it is in good shape. I am currently reworking the...
