P.m sent
Type: Posts; User: Tony Fox
P.m sent
15' Ethernet cable for Lowrance.
P.M if you have an extra.:thumb up2:
Sounds like a sticking power key. Maybe attempt exercising it a bit?
Copy, Thank you much!
My smaller update cards have walked off, so I ordered new 32gb cards. Cannot find info in specs, but does any know if the Elite 7 will allow a 32GB card to do a S/W update?
Some older units would...
If the owner wired it correctly, there should be a switched source. If there are any accessory switches on the console, it may wired to require the switch be turned on to power the NMEA 2000 network...
I just replaced a cable connector, it was simple and effective using this solderless connector....
Just wanted to advise about a BBC sponsor ( K and K Kustomz ) that exceeded the norm. I sent in my Lowrance HDS graph cover, and they dipped it, sent it back in a week with the coolest graphics!...
If the O.P is still interested, and would like a third Opinion,
The first reply ( from NoCAL) to your inquiry was spot on as always. GPS signal is Shared over NMEA, "Not Enet!":thumb up2:
Sorry mate, Misread! Simply remove your existing tach, and tape off the wires ( as your rpms, will now come from your NMEA 2000 network/engine interface. As for the Pitot tube pick up that runs your...
Reading the operators manual may help with your questions. At least it would be an easier way to start.
http://www.lowrance.com/upload/Lowrance/Documents/Manuals/LMF-400_0151-222_111506.pdf
Thank you Sir, I got it ordered from Evinrude!
The White part#was correct http://www.bassboatcentral.com/boardstuff2/beers.gif
I was hoping for a little bottle, but all I can find is the spray can. I just have a little chip and do not wish to make a mess.
I believe the Paint can part# is 0777171 (White)
I was also...
Hey thanks for responding mate. I have figured it out . It is actually not a Trim/Tilt unit. It was designed for tilt only basically limitiing the strength of the hydraulic unit. With the high thrust...
While helping a friend break in a new Suzuki 9.9 high thrust yesterday we encountered a strange issue. Out of water the trim/tilt unit worked great(full range/no sound). While motoring in the water...
I use the same motor, only with electric start, and wired controls to the helm. EZ steer for the steering and hydraulic lift on the kicker bracket. It is also capable of charging your main batteries...
You want honesty, I don't know about the 200hp but my new 115hp has had a few issues that turned out to be easily fixed with trips to the dealer. Hope your authorized service techs are close to your...
You will get more accurate info on here if you can provide the complete model # and serial #. These guys have a way of looking up the service histories and a list of common fixes for each model....
Seemed to be the same kind of issues you were experiencing. Apparently the s/w update (dont know the number) and the dealer saying they re-indexed the plugs, took care of the issue. At least from the...
Just an update, I called and spoke with Al@ Cust SVC. and he said that it was "Not" operating outside safe parameters, and that temperature is O.K. So Of course I was so excited I neglected to ask...
Called the dealer Saturday, He said "Its not a big deal, They will get hot like that idling. If it overheats,the warning horn will be heard,and it'll still be under warranty " . So I guess Ill have...
Thanks for the advice. I just got my boat back from the dealer after one and a half weeks waiting for them to Install the s/w update to cure my starting issues. Im wondering if they even read the...
The Idle Temp was 199 deg.F . When I opened it up, within one minute came down to 105. Just curious if this is cause for concern? I was not Idleing for more than 5min.
2007 E-TEC 115 DSLUC S/N# 05172230. Forgive me if you have answered this before, I could not find it in my search. What is a concerning temp while idling around? I have the digital I-command...
"BUMP" "OVER"!